Advertisement
Pole Mounting :This series also include a pole mount option. The
pole mount socket located on the bottom of the speaker may be
used to secure the speaker to a speaker tripod. Always be sure to
fellow the guidelines listed be blow when pole mounting your speaker.
1. Always be sure the stand is designed to support the weight of the
speaker
2.In outdoor situations that are prone to windy conditions and strong
wind gust , be sure to use sandbags as additional tripod support ,
this will greatly reduce the risk of tipping
3.Do not stack speakers on top of each other when mounting on a
tripod. Only one speaker should be mounted to a tripod at one time
4.Always position the tripod legs away from foot traffic
5.Extend the tripod legs to their fully extended position to avoid
accidental tipping
6.Observe and follow all safety guidelines and regulations specified
by the tripod manufacturer
7.Be sure the tripod is situated on a flat ,level , and stable surface
8.Always tighten all tripod locks
Distributed by:
TechBrands by Electus Distribution Pty.Ltd.
320 Victoria Rd, Rydalmere
NSW 2116 Australia
Ph: 1300 738 555
Int`1: +61 2 8832 3200
Fax: 1300 738 500
www.techbrands.com
CS-2490
OWNER`S MANUAL
Advertisement
Table of Contents
Related Manuals for DigiTech CS-2490
Summary of Contents for DigiTech CS-2490
- Page 1 CS-2490 Pole Mounting :This series also include a pole mount option. The pole mount socket located on the bottom of the speaker may be used to secure the speaker to a speaker tripod. Always be sure to fellow the guidelines listed be blow when pole mounting your speaker.
- Page 2 IMPORTANT SAFETY SYMBOLS Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or CAUTION sold with the apparatus. When a cart is used, RISK OF ELECTRIC SHOCK use caution when moving the cart/apparatus DO NOT OPEN combination to avoid injury from tip-over.
- Page 3 INSERT TAPE OUT UNBAL LINE IN UNBAL LINE IN UNBAL STEREO LINE IN 3/4 STEREO LINE IN 5/6 ROOM/PHONES 8 ohms CS-2490 CS-2490 LO - CUT LO - CUT 100Hz 100Hz DIGITAL EFFECT GAIN GAIN GAIN GAIN . . .
- Page 4 Controls and Features CS-2490 REAR PANEL DESCRIPTION CS-2486 LEVEL LEVEL INPUT LINE INPUT VOLUME TREBLE LINE BASS CLIP POWER AC 240V 50Hz 1.POLE MOUNT SOCKET-This socket is designed to fit a standard speaker pole mount or tripod speaker stand. 2.RIGGING POINTS-This series speaker has rigging points . These points are to be used to fly or suspend the speaker in the air by some means .
Need help?
Do you have a question about the CS-2490 and is the answer not in the manual?
Questions and answers
microphones to suit cs 2490
mics 521.7mhz available to suit audio cs 2490