Panasonic Lumix DMC-LX3 Operating Instructions Manual page 24

Preparation
[Fn BUTTON SET]
Refer to P39 for details about the review.
•
Refer to P74 for details about the [REC] Mode Menu.
•
[MONITOR]
[LCD MODE]
LCD
The brightness of the pictures displayed on the LCD monitor is increased so some subjects
•
may appear differently from actuality on the LCD monitor. However, this does not affect the
recorded pictures.
The LCD monitor automatically returns to normal brightness after 30 seconds when recording
•
in Power LCD mode. Press any button to make the LCD monitor bright again.
If the screen is difficult to see because of light from the sun etc. shining on it, use your hand or
•
another object to block the light.
The number of recordable pictures decreases in Auto Power LCD mode and Power LCD mode.
•
[GUIDE LINE]
The [PATTERN] setting is fixed to [
•
[HISTOGRAM]
24
VQT1T46
Assign Mode Menu to 4 button. It is convenient to register
[REC]
Mode Menu that is used often.
[REC]
[REVIEW]/[FILM MODE]/[SENSITIVITY]/[WHITE BALANCE]/
[METERING MODE]/[AF MODE]/[I.EXPOSURE]
(Recording mode only)
Adjust the brightness of the LCD monitor in 7 steps.
These menu settings make it easier to see the LCD monitor when
you are in bright places.
[OFF]
„ [AUTO POWER LCD]:
The brightness is adjusted automatically depending on how bright
it is around the camera.
... [POWER LCD]:
The LCD monitor becomes brighter and easier to see even when
taking pictures outdoors.
Set the pattern of the guide lines displayed when taking pictures.
You can also set whether or not to have the recording information
displayed when the guide lines are displayed.
[REC. INFO.]:
[OFF]/[ON]
] in the Intelligent auto mode.
This allows you to set either to display or not display the
histogram. (P43)
[OFF]/[ON]
(P44)
[PATTERN]:
[ ]/[ ]