Opel 2015 Zafira Tourer Owner's Manual page 193

Hide thumbs Also See for 2015 Zafira Tourer:
Table of Contents

Advertisement

Button logic operates the systems by
pressing as following:
■ front-rear parking assist is active:
short press deactivates front-rear
parking assist.
■ front-rear parking assist is active:
long press activates advanced
parking assist if a forward gear is
engaged.
■ advanced parking assist is active:
short press activates front-rear
parking assist.
■ advanced parking assist is active:
long press deactivates advanced
parking assist.
■ advanced parking assist and front-
rear parking assist are active: short
press deactivates both systems.
Activation
When reverse gear is engaged, the
front and rear parking assist is ready
to operate.
The front parking assist is also
activated automatically at a speed up
to 11 km/h.
An illuminated LED in the parking
assist button D indicates that the
system is ready to operate.
If the vehicle exceeds a speed of
11 km/h, the front parking assist is
deactivated. The front parking assist
is always reactivated when vehicle
speed drops below 11 km/h.
Indication
The system warns the driver with
acoustic signals against potentially
hazardous obstacles behind and in
front of the vehicle. Depending on
which side of the vehicle is closer to
an obstacle, you will hear acoustic
warning signals on the respective
side of the vehicle. The interval
between the sounds becomes shorter
as the vehicle gets closer to that
obstacle. When the distance is less
than approx. 30 cm, the sound is
continuous.
Additionally, the distance to obstacles
may be shown in the Driver
Information Centre 3 115.
Driving and operating
The distance to a front and rear
obstacle is indicated by changing
distance lines around the vehicle.
Rear obstacles are indicated
acoustically and visually at the same
time.
Front obstacles are indicated visually
first. At distances less than 80 cm an
acoustic signal also sounds.
The distance indication in the Driver
Information Centre can be inhibited
by vehicle messages with a higher
priority. After approving the message
by pressing the SET/CLR button on
the turn signal lever, distance
indication appears again.
191

Advertisement

Table of Contents
loading

Table of Contents