Ensure that the head unit has been paired with the speed sensor before using your computer. If you have any questions or problems, please contact your local Giant dealer or go to Giant's official website: www.giant-bicycle.com Let's go ride!
Package contents 1. Head unit 2. Head unit battery 3. Handlebar/stem mount 4. Mount base pads (x 2) 5. Speed sensor 6. Speed sensor battery 7. Wheel magnet 8. Rubber straps (x 3) 9. Zip ties (x 2)
Installation instructions Battery Mounting Install the battery in the back of the installation main unit. Use a coin to open and close the cover. Install the head unit mount with the appropriate base pad and rubber strap. The head unit can be mounted in three different locations: (A) Stem (B) Handlebar...
Display & buttons Complete display Sleep display Flashes when a signal is Press the M key to turn on the 1. Wireless received from the speed backlight. Backlight will turn on signal 4. Smart backlight sensor only during its preconfigured "on"...
Display modes Press the M key to cycle between functions Display Functions Trip distance Total trip distance TDST Press and Riding time release M key Total riding time TRTM Average speed Maximum speed Calories burned TCAL Total calories burned Odometer...
Setup Mode 1. Wheel circumference setting Press the M key and release it Press the M key for 2 seconds and release it Time setting Press the S key and release it 3. Unit setting 4. Weight setting 2. Time setting...
Wheel circumference setup *Same as Bike2 setting Press S to enter setup mode. Press M to select from ten pre-programmed wheel WHEEL CIRCUMFERENCE sizes. If wheel size is not shown, enter a measured wheel circumference. Follow the setup process and press M to select a value and press M2 to confirm it. After the size or circumference is entered, press M2 to go to time setup.
Time setup After entering time setup mode, press M to select 12Hr or 24Hr. Press M2 to confirm selection. Press M to select hour value. Press M2 to confirm. Press M to select minute value. Press M2 to move to unit/weight setup. Set time format Set time Unit/weight...
Unit/weight setup After entering unit/weight setup mode, press M to select km or mi units. Press M2 to confirm. Press M to select your weight. Press M2 to advance to next number. Press M2 to move to smart backlight setup. Unit setting Weight setting Smart backlight...
Smart backlight setup / maintenance alert setup After entering smart backlight setup, press M to After entering maintenance alert mode, press M to set select smart backlight "on" time. Press M2 to maintenance alert to your desired distance (300-700 km or confirm.
Reset trip logs / reset Reset trip logs Reset To reset DST, RTM, AVE, If the computer does not MAX, & CAL, navigate to any function normally, or the of those modes and press M screen is blank after the for 3 seconds.
Troubleshooting Problem Possible cause Solution Problem Possible cause Solution Battery is not installed. Install battery Adjust the sensor or magnet Gap between the sensor and to reduce the gap to less magnet is too large No image than 5mm Battery is dead Replace battery on screen Abnormal...