Honda 1991 Prelude Owner's Manual page 121

Changing a Flat Tire (cont'd)
4. (2,0 Si)
Remove the center cap from the wheel cover by turning the lock
to 90°.
(Si)
Remove the center cap from the wheel by prying it out with a
common flat screwdriver (not provided in the tool bag).
(2.0 Si)
CENTER CAP
CAUTION:
(On the Si model)
Hold the center cap with your hand then pry it off using a rag to
protect the cap and the wheel.
5. Use the lug wrench to loosen the wheel lug nuts counterclock-
wise one-half turn.
Follow tire changing preparations and procedures carefully to
reduce the possibility of injury. The jack is designed for changing
tires only. STAND CLEAR, DO NOT get under the car and DO NOT
run the engine when the car is supported only by the jack.
6. Place the jack under the jack point nearest the wheel you are
removing; align the jack head so the car frame will fit in the recess
as you raise the jack.
To reduce the possibility of injury, be sure to use the jack provided
with the car and the correct jacking points; never use any other
part of the car for jack support.
(Si)
CENTER CAP
RAG
FLAT
SCREWDRIVER