SAFETY PRECAUTIONS Read all of the instructions before using this appliance. When in use always exercise basic safety precautions including the following • Use of the is appliance is intended only for it’s intended purpose as described in the manual •...
Parts & Features 1. Interior light 2. Flat wire shelves (WINE105 has scalloped wine shelves) 3. Door handle 4. Adjustable feet (Not shown)
Page 4
Installing Your Cooler Unpacking Your Cooler 1. Remove all packaging material. This includes the foam base and all adhesive tape. 2. Inspect and remove any remains of packing, tape or printed materials before powering on the cooler. Levelling Your Cooler •...
Page 5
Cooler Features and Use Initial Setup Once you have plugged the unit into an electrical outlet, let the unit run for at least 30 minutes to acclimatise before making any adjustments. Temperature Adjustments • The cooler is preset from the factory to automatically accommodate temperature requirement for wines by setting the thermostat to position 4 •...
Page 6
There will be a three degree deviation +/- from the temperature you select and the temperature indicated on the LED readout. This occurs because the cooler activates and deactivates trying to maintain your desired temperature. There is often a ten degree deviation between the top and bottom shelves of the cooler, therefore, if you have set the cooler at 10˚c and have a mix of red and white wines, you may want to put the white wine...
Page 7
Proper Cooler Care and Cleaning Cleaning and Maintenance To avoid electric shock, always unplug your cooler WARNING: before cleaning. Ignoring this warning may result in death or injury Before using cleaning agents, always read and follow CAUTION: manufacturers instructions and warnings to avoid personal injury or product damage General •...
Troubleshooting Cooler Does Not Operate • Check the cooler is plugged in • Check there is power going to the socket it is plugged in Cooler Appears Too Warm • Frequent door opening • Allow time for recently added stock to reach desired temperature •...
Page 9
Changing The Lamp Tube & Starter 1. Take off the lamp cover lightly 2. Take off the lamp tube 3. Put a new lamp tube in the holder 4. Take back the lamp cover, place it in it’s original position 5.
Reversing The Door How to Reverse The Door Remove the lower hinge by loosening and removing the screws with a screw • driver Carefully lower the door and remove it • Move the pivot pin to the opposite hole on the lower hinge •...
Need help?
Do you have a question about the BC105 and is the answer not in the manual?
Questions and answers