Chevrolet Corvette 2016 Manual page 228

1. Remove the two engine oil
drain plugs from the bottom of
the engine oil pan. One drain
plug drains the external oil tank
via the oil transfer supply line.
The other drain plug drains
residual oil from the crankcase
sump. Allow the oil to drain.
2. Once the oil has been drained
from the engine, remove the
engine oil filter and allow the oil
to drain.
3. Reinstall both drain plugs and
tighten them to 25
(18 lb ft).
4. Replace the oil filter and
tighten it three-quarters to one
turn after gasket contact. See
Maintenance Replacement
Parts 0 308 for the correct filter.
5. Oil is filled through the opening
in the top of the external
engine oil tank. Remove the oil
fill cap.
6. Add oil to the oil tank. See
Capacities and Specifications
0 312.
7. Install the oil fill cap and insert
the dipstick, if removed.
8. Start the engine and let it run
at idle for at least 15 seconds.
This will circulate the fresh
engine oil through the
lubrication system.
9. Shut off the engine and check
the oil level as described under
Checking Engine Oil
(Z51 and Z06).
Selecting the Right Engine Oil
Selecting the right engine oil
depends on both the proper oil
specification and viscosity grade.
See Recommended Fluids and
Lubricants 0 307.
Specification
Ask for and use engine oils that
meet the dexos1 specification.
Vehicle Care
Engine oils that have been
approved by GM as meeting the
dexos1 specification are marked
with the dexos1 approved logo. See
www.gmdexos.com.
GM recommends Mobil 1
oils that show the dexos1 approved
logo for its dry sump equipped
engines.
Caution
Failure to use the recommended
engine oil can result in engine
damage not covered by the
vehicle warranty. Check with your
dealer or service provider on
whether the oil is approved to the
dexos1 specification.
Viscosity Grade
Use SAE 5W-30 viscosity grade
engine oil.
Cold Temperature Operation: In an
area of extreme cold, where the
temperature falls below 29 °C
( 20 °F), an SAE 0W-30 oil may be
used. An oil of this viscosity grade
227
®
engine