Seal Adjustment; Maintenance; 12.1 Air - Unit; Cleaning - T&D fromm A391.0002 Operation Manual

11 SEAL ADJUSTMENT

The sealing mechanisms stamping and cutting depth can be adjusted with the socket wrench N4.1408
delivered with the tool.
Procedure:
• Place the tool as shown.
• Loosen both screws N1.1168 and unscrew
them about three rotations.
• If sealing mechanism is adjusted too high
displace the stop in the direction of the base
plate.
• If sealing mechanism is adjusted too low
displace the stop in the direction of the cover.
• Tighten screws.

12 MAINTENANCE

Depending on the working conditions and the use of the tool the following maintenance has to be made
periodically:

12.1 Air - unit

• Checking the air-pressure daily.
• Checking oil-level daily.
• The water separator must be emptied before it is full (unless automatic).
• The filter has to be cleaned following the instructions of the manufacturer of the air- unit.
Oil for the air-unit
HL or CL ISO-VG 10

12.2 Cleaning

If impact of dirt and dust is considerable and if painted (cinccoated) straps are used the feed wheel must be
cleaned regularly. Normally it is sufficient to blow out this part by using an air gun.

12.3 Lubrication

The worm gear is filled with MOLYKOTE LONGTERM 00. Use the same type of grease after repairs.
When being exchanged, all valve parts and other movable parts have to be greased with grease of type
ESSO BEACON 2 or with any equivalent product.
Assembling notice:
The screws N1.1182 and N1.1184 have to be
tightened after each disassembling with the
prescribed torques.
The use of a torque wrench is absolutely
necessary.
14
N1.1182 = 42 Nm
N1.1184 = 85 Nm
a3910002en.teil2