Chevrolet Camaro 2016 Operating Manual page 201

200 Driving and Operating
3. Remove the calipers (3) from
the knuckle.
4. Remove the brake rotors (2).
5. Remove the original front
splash shields (1).
6. Remove the lower control arm
deflectors.
7. Detach the engine harness
clips from the lower control arm
deflector and remove the lower
control arm.
8. Install the small splash shields
with two screws (2) per corner.
Torque to 9 Y (80 lb inch).
Caution
Failure to reattach the engine
harness clips correctly could
cause possible interference with
the wheel speed sensor and
vehicle damage.
9. Re-attach the engine harness
clips by pushing them from the
bottom up, on the back tab.
On the original deflector, the
push pins are pushed from the
top down.
10. Install the tall deflectors with
three screws (1) per corner.
Torque to 3.3 Y (29 lb inch).
11. Install the front rotors with one
screw per corner. Torque to
9 Y (80 lb inch).
12. Apply liquid thread adhesive to
the caliper bolts (GM Part
No. 9985399 Loctite 272
Goodwrench 12345493). Install
the calipers with two screws (1)
per corner. Torque the caliper
bolts to 200 Y (148 lb ft).