Creating An Ethernet Network Profile - Motorola USBw 100 Series User Manual

5. If you are configuring a profile for a closed network, check
non-broadcast
6. If the network whose profile you are configuring does not use WEP or
WPA encryption, no further security configuration is necessary, the
Enable data encryption box
configuration is necessary on this page.
7. If the network does use WEP or WPA encryption, check the
data encryption
(see Enabling WiFi Data Encryption for instructions).
8. Click Next. The General page appears.
9. Configure the settings on the General page and then click Finish.

Creating an Ethernet Network Profile

Follow these steps to create an Ethernet Network Profile:
1. Click the
Connection Manager software. The Network Profiles window will now
be displayed.
2. Click on the
the window.
3. Click the
appears.
4. In the fields provided, enter the criteria that the Motorola Connection
Manager should use when attempting to match this profile to Ethernet
networks that you connect to. You must enter a value in at least one
of these fields (it does not matter which). Additional fields are
optional.
5. Click
6. The default selections on the IP Properties page are correct for most
networks. If, however, this particular network requires specific IP
address and/or DNS server settings, you can specify them here.
7. Click Next. The General page appears.
32
network.
box and configure the WiFi data encryption settings
Profiles button in the main window of the Motorola
Ethernet heading in the list of profiles on the left side of
Add button. The Ethernet page of the Add Profile Wizard
Next to continue to the IP Properties page.
Creating and Managing Network Profiles
should remain unchecked and no further
this is a
Enable
USBw 100
MAR 2009