Audio System Connection; Usb Playback; Remote Control - Hyundai MS 131 DU3 Instruction Manual

CONNECTIONS

AUDIO SYSTEM CONNECTION

Speaker Output
Connect the speakers to speaker output terminals with their
attached speaker cables (white for +, black −).
LINE IN
This unit has an extra group of audio input terminal.
You can input the analogue stereo audio signals from extra devices such as
VCD, CD, VCR,MP3 player, etc.
Use the audio cable to connect the stereo audio output terminals of a VCD,
CD, VCR player to the input terminal (LINE IN) of this unit. Its corresponding
signal source is LINE IN which can be available by pressing [SOURCE] on
the remote control.

USB PLAYBACK

• Insert a USB drive in the USB slot, then press [USB]
to enter the connected USB drive and you can playback the readable files in it.
NOTE:
• In case the player breaks down when you insert a USB drive into the player, turn off the player,
disconnect the power cord from the AC outlet and unplug the USB drive from the player.
Then, power on the player again. The player will resume the normal status.

REMOTE CONTROL

Remote Control Operation
Insert the batteries into the remote control. Point the remote control at the remote sensor on
the front panel. The remote control works within a distance of about 8 metres from the sensor
and within an angle of about 30 degrees from the left and right side.
Battery Installation
1) Remove the battery
compartment cover on
the back of the remote
control.
Note:
• Remove the batteries when you do not intend to use the remote control for a long time.
• Do not mix new and used batteries, or different types of batteries.
• Weak batteries can leak and severely damage the remote control.
• The batteries must not be exposed to excessive heat source, such as sunshine, fire or any
other things like that.
• Be environmentally friendly and dispose of batteries according to your government regulations.
2) Load two AAA / 1.5 V batteries
into the battery compartment
making sure that the batteries
have been inserted with
the correct polarities matching
the symbols +, − as indicated
inside the battery
compartment.
EN - 25
3) Replace the cover.
EN