Binding The Transmitter And Receiver; Specifications - Carson Reflex Stick Pro 3 Instruction Manual

BinDing tHe tranSmitter anD receiVer

1. Turn on the receiver power. Press the SW
switch. The receiver's LED should start
flashing.
ATTENTIoN
Keep the transmitter and receiver not over 40 cm
apart when setting and binding.

SpeciFicationS

transmitter
receiver
It is CARSON's policy that we strive to improve the quality of our products. Therefore CARSON may alter specifications of our products at
any time without any notice.
2. Turn on the transmitter.
During the binding process no other transmit-
ter should be operated in the vicinity at the
same time!
Frequency 2.4 GHz
Power supply DC 4.8 - 6 V=
Power Supply DC 6.0~11.0 V
Dimensions 35 x 26 x 14 mm
3. When the LED on the receiver
becomes solid, the binding process
is completed.
23 // GB