Electrical Checking - Sony D-NE10 Service Manual

QQ
3 7 63 1515 0
The CD section adjustments are done automatically in this set.
In case of operation check, confirm that RF level.
Precautions for Check
1. Perform check in the order given.
2. Use YEDS-18 disc (Part No.: 3-702-101-01) unless otherwise
indicated.
3. Power supply voltage requirement : DC3 V in terminals for the
VOLUME button
HOLD switch
AVLS function setting
G-PROTECTION function setting : 1
Checking Location:
– MAIN board (Side A) –
TE
L 13942296513
TP649
TP701(AGND)
www
.
http://www.xiaoyu163.com

ELECTRICAL CHECKING

charging stand.(J401,402)
: Minimum
: OFF
: OFF
15 1
x ao u163
y
i
http://www.xiaoyu163.com
SECTION 4
2 9
8
RF Level Check
Condition:
• Hold the set in horizontal state.
Connection:
MAIN board
TP649 (RF)
TP701 (AGND)
Procedure:
1. Connect the oscilloscope to the test points TP649 (RF) and
TP701 (AGND) on the MAIN board.
2. Set a disc. (YEDS-18)
3. Press the u button.
4. Check the oscilloscope waveform is as shown below.
A good eye pattern means that the diamond shape (◊) in the
center of the waveform can be clearly distinguished.
RF Signal reference Waveform (Eye Pattern)
VOLT/DIV : 100 mV (With the 10:1 probe in use)
TIME/DIV : 500 ns
Q Q
3 6 7 1 3 1 5
To watch the eye pattern, set the oscilloscope to AC range and
increase the vertical sensitivity of the oscilloscope for easy watch-
ing.
5. Stop revolving of the disc motor by pressing the x button.
co
.
9 4 2 8
Oscilloscope
(AC range)
2 k Ω
+
–
0 5 8 2 9 9 4 2 8
RF level
0.45 to 0.65 Vp-p
m
D-NE10
9 9
9 9
11