Introduction - Baxi Brazilia F5 Installation And Servicing Instructions

Brazilia F5, F5S & F8S
1.0 Introduction – Page 4
Notice
Discolouration of wall surfaces
Most heating appliances generate warm air convection
currents and transfer heat to any wall surface against which
they are situated.
Some soft furnishings (such as blown vinyl wallpapers) may
not be suitable for use where they are subject to
temperatures above normal room levels and the
manufacturers advice should be sought before using this
type of wall covering adjacent to any heating appliance.
The likelihood of wall staining from convected air currents
will be
increased in environments where high levels of tobacco
smoke or other
contaminants exist.
4
Supplied By www.heating spares.co Tel. 0161 620 6677
1.1 Description
1. The Baxi Brazilia F is a range of room sealed gas convector
appliances designed to be used with gas type G20 (Natural
Gas) at supply pressure 20 mbar.
2. The Baxi Brazilia F range is also available for use with gas
type G3t (Propane) at supply pressure 37 mbar. The procedure
for installation, servicing etc. is the same for both Natural Gas
and Propane models.
IMPORTANT: The appliance must only be used on its
designated gas type. This is indicated on the data label.
3. The appliance provides warm air by natural convection and
flueing is by means of a concentric balanced flue arrangement.
4. The appliance is controlled by a control knob which operates
the ignition and alters the heat output. The control knob has five
positions giving a choice of three output rates:
• •
Position
Position I
Position
Position II
Position III
1.2 Installation
1. The appliance is suitable for installation only in G.B. and I.E.
and should be installed in accordance with the rules in force.
For Ireland install in accordance with I.S.813 "INSTALLATION
OF GAS APPLIANCES". The installation must be carried out
by a CORGI Registered Installer or other competent person and
be in accordance with the relevant requirements of GAS
SAFETY (Installation and Use) REGULATIONS latest edition,
the BUILDING REGULATIONS issued by the Department of
the Environment, BUILDING STANDARDS (Scotland)
(Consolidation) REGULATIONS issued by the Scottish
Development Department and the LOCAL BUILDING
REGULATIONS. Where no specific instructions are given,
reference should be made to the relevant BRITISH STANDARD
CODES OF PRACTICE.
2. This appliance must be installed in accordance with the
manufacturers instructions and the rules in force.
3. Read the instructions before installing or using this
appliance.
NOTE: All illustrations show F 55, unless otherwise
indicated. The procedure for installation, commissioning,
servicing etc. is the same for all Brazilia F models.
1.3 Important Information
This product Contains Refractory Ceramic Fibres (R.C.F.) which
are man-made vitreous silicate fibres. Excessive exposure to
these materials may cause temporary irritation to eyes, akin and
respiratory tract. Care must be taken when handling these
articles to ensure the release of dust or fibres is kept to a
minimum. To ensure that the release of fibres from these
articles is kept to a minimum, during installation and servicing it
is recommended that a H.E.P.A. filtered vacuum is used to
remove any dust, soot or other debris accumulated in and
around the appliance. This should be performed before and
after working on the installation. It is recommended that any
replaced item(s) are not broken up but sealed within heavy duty
polythene bags and clearly labelled R.C.F. waste". This is not
classified as "hazardous waste" and may be disposed of at a
tipping site licensed for the disposal of industrial waste.
Protective clothing is not required when handling these articles
but it is recommended that gloves are worn and the normal
hygiene rules of not smoking, eating or drinking in the work area
are followed and always wash hands before eating or drinking.
Baxi Heating Ltd.
OFF
LOW
IGNITION
MEDIUM
HIGH