Table of Contents
Advertisement
M1-14208(2) 3/3
TEMPORARILY
SEITING
UP AND CONNECTING
MAIN PWB ASSEMBLY
The following
is an example of how to place and connect the main PWB not requiring a jig, when repairing the
-
CP-1 PWB assembly (Fig. 1.1.4)
1.
Place the mechanism
main unit at the fixed position on
the chassis.
2.
Connect the 29-wire flat cable to the MC-2 PWB, and the
8-wire flat cable to the VP-1 PWB Ass'y respectively.
Connect the TM-1 PWB Ass'y to operate VCR by using
the remote control.
3.
Place the CP-1 PWB Ass'y above the mechanism
main
unit along the cassette holder. Insert
the tip (L) of the
terminal board into the opening (M) at the side of the
chassis, as shown in the enlarge view.
M-TEIUE-4
Ass'y
VP-I
L)
Mecha
MC-2 PWB
Fig. 1.1.4
w
–4–
Advertisement
Table of Contents
