elmeg T444 User Manual page 14

Con fi gu ra ti on ex am ples Ad dress as signment by DHCP -Re com men ded con fi gu ra ti on - (De fault setting)
Note
The net work adap ter con nec ted to the PABX sys tem must be lin ked to the TCP/IP pro to col, which is a com po nent
of Wind ows. You may have to ma nu al ly add this pro to col. The net work adap ter may only be lin ked to the T-DSL /
PPP0E pro to col, espe ci al ly if a stand-alo ne ver si on of the T-DSL dri ver has been in stal led. Add the TCP/IP pro to col
ma nu al ly using the but tons »Add«, »Pro to col«, »Mi cro soft«, »TCP/IP«.
·
Then spe ci fy that the PC is to re cei ve its IP ad dress au to ma ti cal ly. All ot her set tings, for ex am ple DHCP,
net work mask, gate way and DNS ser ver should be de-ac ti vat ed or blank. The PABX sys tem au to ma ti cal ly
trans fers all re qui red set tings to the client (PC) via DHCP.
·
Con firm your set tings by cli cking OK.
Example Windows 2000 and Windows XP:
·
Open the Con trol Pa nel from the Wind ows Start Menu.
·
Un der Wind ows 2000 open the fol der »Net work and Dial-up Con nec tions«.
·
Un der Wind ows XP open the fol der »Net work con nec tions«.
·
Se lect the »LAN Con nec ti on« for the PABX by pres sing the right mou se but ton. Then click »Pro per ties«.
·
Se lect »TCP/IP« and click »Pro per ties«.
·
Then spe ci fy that the PC is to re cei ve its IP ad dress au to ma ti cal ly. All ot her set tings, for ex am ple DHCP,
net work mask, gate way and DNS ser ver should be de-ac ti vat ed or blank. The PABX sys tem au to ma ti cal ly
trans fers all re qui red set tings to the client (PC) via DHCP.
·
Con firm your set tings by cli cking OK.
Note
Also fol low the in struc tions gi ven in the do cu men ta ti on and the Help functi on of your ope ra ting sys tem. If it is not
pos si ble to set up a con nec ti on to the PABX, or to the In ter net, re fer to the sec ti on »Che cking the LAN client (PC)
con fi gu ra ti on« in this ma nu al.
10