Edison TX-928-H Operating Manual

Edison TX-928-H Operating Manual

Advertisement

TX-928-H

Operating Manual

The manual is subject to change without notice
Version:V1-2

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the TX-928-H and is the answer not in the manual?

Questions and answers

Summary of Contents for Edison TX-928-H

  • Page 1: Operating Manual

    TX-928-H Operating Manual The manual is subject to change without notice Version:V1-2...
  • Page 2: Table Of Contents

    Product Introduction CONTENTS TX-928-H series are available for boiler, manifold and underfloor heating system with 7-day, 6-period time program control. Models are with NTC sensor to Product Introduction detect ambient and floor temperature and do the control by compared with the Product Features setting one.
  • Page 3: Technical Datas

    Technical Datas LCD display and Functions 1. Manual control mode Consumption:<2W LCD displays “ ”, the controller is under manual setting. In the ~240VAC 50/60Hz Power supply: “ON” state, press “ ” to swich the manual control mode or time program control mode.
  • Page 4: Dimensions

    Dimensions General Setting 1. Power on / off: Presss “ ” to turn on or turn off the controller. When power is off, it displays “OFF” and current time alternatly; when power is on, it displays setting temp. and current time alternatly. 2.
  • Page 5: Advanced Setting

    General Setting Advanced Setting Normally set by technicians during the first installation. Press Periods Coins Default Time Default Temperature “ ” first, then press “ ” for 3s to enter into setting in the “ON” state. Tips: (Amend the datas via advanced setting, press “ ” to save and exit the setting.) 01.
  • Page 6: Wiring Diagrams

    Advanced Setting Wiring Diagrams 06. Rle Setting of passive linkage and main output, press “ ” or The highest elevation for the controller working under full load “ ” to change the condition of linkage; “00” means situation is 2500m; or if higher than 2500m, the rated power of correspond with main loop output, “01”...
  • Page 7: Trouble Shooting

    Trouble Shooting Fault Reasons Methods phenomenon No display Power line input Check the power line errors or without connection and the Input power supply Display Er1 Internal sensor C h e c k t h e p i n o f errors i n t e r n a l s e n s o r i f there is a short cirsuit...

Table of Contents

Save PDF