Cleaning And Maintenance - Medisana MediTouch 2 Instruction Manual

9.2 Cleaning and maintenance

Monitor
®
Your MediTouch 2 connect blood glucose
monitor is a high-precision instrument. Handle
with care to avoid damaging the electronics and
prevent defects. You do not need any additional
cleaning to maintain your monitor, provided it has
not come into contact with blood or control solu-
tion. Keep the monitor free from dirt, dust, blood
and water stains.
Observe the following instructions:
• Make sure that the monitor is switched off.
• Clean the surface of the monitor with a soft
cloth slightly dampened with 70-75 % ethanol.
• Never use abrasive detergents or strong
brushes.
• Never use cleaning agents on the monitor.
• Never immerse the monitor in water. Do not
allow water or other liquids to penetrate the
monitor. Dry the monitor with a lint-free cloth
after cleaning.
• Make sure that dirt, dust, blood, control so-
lution, water or alcohol do not penetrate the
G
test strip slot or get onto the buttons on the in-
side of the monitor.
• Do not expose the monitor to extreme tempe-
ratures.
• Store the monitor in the zip bag provided after
each use.
• Do not store the monitor and the test strips in
a vehicle, bathroom or refrigerator.
i
• Remove the battery if you do not intend to use
the monitor for one month or longer.
Lancing device
Clean the lancing device with a slightly damp
cloth (with water and a mild detergent). Do not
immerse it in water or other liquids and never
allow water or other liquids to penetrate the inside
of the lancing device. To disinfect the protective
cap, soak it in 70 % - 75 % cleaning alcohol for
10 minutes once a week after cleaning. Leave the
cap to dry thoroughly after disinfecting.
9 Miscellaneous
G
47