ARO SLE15B-1 O-Q Operator's Manual

ARO
OPERATOR'S MANUAL
Tool Products
INCLUDING: OPERATION, INSTALLATlON & MAINTENANCE
SECTION
M31
MANUAL
4
Released:
3-01-96
MODELS SLE15B-1 O-Q, SLE15B-20-Q SLE26B-3-Q
SLE26B-7-Q SLE26B-12-Q, STE40B-7-Q, SPE15B-10-Q,
SPE15B-20-Q, SPE26B-3-Q, SPE26B-7-Q, SPE26B-12-Q
AND SPE40B-7-Q ELECTRIC SCREWDRIVERS
IMPORTANT SAFETY INFORMATION ENCLOSED.
READ THIS MANUAL BEFORE OPERATING TOOL.
FAILURE TO OBSERVE THE FOLLOWING WARNINGS COULD RESULT IN INJURY.
Always wear eye protection when operating or
.
performing maintenance on this tool.
Power tools can vibrate in use. Vibration,
repetitive motions, or uncomfortable positions may
be harmful to your hands and arms. Stop using
any tool if discomfort, tingling feeling or pain
.
occurs. Seek medical advice before resuming use.
Keep work area clean. Cluttered areas and benches
invite injuries.
.
Consider work area environment. Don't expose
power tools and chargers to water. Keep work area
.
well lighted. Do not use tool in presence of flam-
mable liquids or gases.
Keep bystanders away. Do not permit unauthorized
personnel to operate this tool.
Store idle tools. When not in use, tools should be
stored in a dry and secured area.
Don't force tool. It will do the job better and more
safely at the rate for which it was intended.
.
Use the right tool. Do not force a small tool or
attachment to do the job of a heavy-duty tool.
Don't use tool for purpose not intended.
.
For example - don't use screwdriver for a drill.
Dress properly. Do not wear loose clothing or
jewelry. They can be caught in moving parts. Rubber
gloves and non-skid footwear are recommended when
working outdoors. Wear protective hair covering to
contain long hair.
Secure work. Use clamps or a vise to hold work.
Operators often need both hands to perform job
functions.
Don't overreach. Keep proper footing, balance, and
a firm grip on the tool at all times.
Maintain tools with care. Keep tools sharp and
clean for better and safer performance. Follow
instructions for lubricating and changing accessories.
Inspect tool cords periodically and if damaged, have
them repaired by an authorized service facility. In-
spect extension cords periodically and replace if dam-
aged. Keep handles dry, clean, and free from oil and
grease.
Remove adjusting keys and wrenches. Form habit
of checking to see that keys and adjusting wrenches
are removed from tool before turning it on.
Avoid unintentional starting. Don't carry tool with
finger on switch.
(continued on page 2)
The use of other than genuine ARO replacement parts may result in safety hazards, decreased tool performance, and
increased maintenance, and may invalidate all warranties.
ARO is not responsible for customer modification of tools for applications on which ARO was not consulted.
Repairs should be made only by authorized trained personnel. Consult your nearest ARO Tool Authorized Servicenter.
It is the responsibility of the employer to place the information in this manual into the hands of the operator.
For parts and service information, contact your local ARO distributor.
ARO Tool & Hoist Products
Ingersoll-Rand Company
ARO
© Ingersoll-Rand Company 1996
Printed in U.S.A.
Part of worldwide Ingersoll-Rand