MTD 500 series Shop Manual page 127

Figure 11.10
Figure 11.11
Cable Jacket End
Figure 11.12
Discharge Chute and Controls (Electric)
8. Disconnect the cables from the Cable Guide. See
Figure 11.10.
9. Unhook the Cable Bracket from the Chute Deflector.
To install the Chute Deflector:
1. Hook the Cable Bracket onto the Chute Deflector.
See Figure 11.11.
2. Attach both cables to the Cable Guide.
NOTE: Forward movement of joystick should result in the
Chute Deflector moving down.
NOTE: If the cables are reversed, the chute operation will
be reversed.
3. Slide the Cable Guide in between the Chute Deflec-
tor and the Cable Bracket.
4. Insert the Cable Jacket Ends into the slots in the
Cable Bracket. See Figure 11.12.
123