Advertisement
F. CHANGING POWER SUPPLY CORD
(See exploded view on page 15)
(1) Unfasten 1 screw for earth and pull out 2 wires of
power cord from terminal plate.
(2) Remove 1 screw for bottom bracket of cord bushing.
(3) Install the new power supply cord with reverse
procedure of above (1) to (2).
WARNING:
For the changing the power supply cord, never use other
than following.
Key No. Order No.
Parts Name
(Mail body Parts-1)
5
617 208 1472 Power cord Ass'y
6
617 180 3211 Cord bush
20
617 140 1349 Bottom bracket
G. REMOVING CERAMIC TRAY ASS'Y
(See Fig.12 )
(1) Take off the cabinet.
(2) Put (insert) a screwdriver in the 9mm diameter hole
locating at lower hinge of left side of the oven cav-
ity. And push the tray up with the screwdriver.
(3) Open the door and take out the tray very carefully.
Hole
H.REMOVING DOOR
Remove 3 hex nuts securing the upper hinge, remove
3 hex nuts securing the lower hinge and remove 1
special screw securing the door arm
(located at the bottom of the door sash).
NOTES
- After replacing the door, be sure to check that the
primary interlock switch, the door sensing switch and
the interlock monitor switch operate normally.
(See pages 1 and 6)
- After replacing the door, check for microwave energy
leakage with a leakage detector. Microwave energy
leakage must be below the limit of 5mW/cm².
Door
Screw driver
Figure 12
I.HOW TO RESET THE MEMORY OF ACCUMULATIVE
COOKING TIME
1. Push the keys step by step as follows,
"
","
"," 8 "," 8 "," 8 "," 1 "
"
","
".
The display will show accumulative cooking time in
the display window.
2. Then push the keys as follows.
" 0 ","
Ｍ
"
Accumulative cooking time will be cleared.
J.CAUTION FOR CUSTOMER ON OPENING AND
CLOSING DOOR
When the Microwave oven is in operation, should the
customer open the door slightly and close, the
breaker of the house will occasionally be cut off.
It is necessary to explain to the customer not to ex-
ercise such matter.
When the Door is opened slightly between 2 or 3mm
distance, primary interlock switch turn OFF, and
operation stops.
However door sensing switch will remain ON, and if
door is closed, primary interlock switch activates and
operation resumes immediately.
At such time microwave oven will start any time.
Therefore a big In-rush current flows, and thus breaker
will be cut off.
K.RELEASING TYPE CONNECTOR
This oven is provied with locked type connector.
When you remove a connector, pull the connector
while releasing the lock by pressing "A" point shown
below.
Do not pull the wire of the connector.
Connector:S1, S2, S102, S104, S105 (Figure 13)
Figure 13
Pull connector case (Never pull the wire)
- 12 -
Figure 14
Figure 15
Hide quick links:
Advertisement
