Exit P Parameter Setting; C Parameter Setting; C1 Power Assist Sensor And Parameter Selection Mode - Electrony S-LCD3 User Manual

1.
○

Exit P Parameter Setting

Among the five P parameter settings, when each parameter setting is completed, if
held button (SW) long for about 2 seconds, all can exit the setting environment and
return to display 1, meanwhile, the current set parameters would be saved.
Under each parameter setting interface, if there's no button operation on the meter for
more than 1 minute, and then the meter will automatically return to display 1, and the
original set parameters will be saved.

C Parameter Setting

After finishing P5 parameter setting, P5 parameter column stops flashing. Within 1
minute after stopping flashing, hold
about 2 seconds to enter C parameter setting environment.
○
C1 Power Assist Sensor and Parameter Select Mode
Set C1 parameter first after entering C parameter setting environment, C1 parameter
column flashes.
C1 is power assist sensor and parameter select mode. Its definition is shown in
following table. C1 setting ranges between 0-7, hold
(DOWN) for selection.
C1 parameter definition table：
S power assist sensors
Forward 5 Signal
ELECTRIC BICYCLE METER S-LCD3 Product User Manual
C1 parameter setting interface
C1 Start
value Sensitivity
00 Standard
01 Lower
button (UP) and
button (UP) or
S-V12 power assist
sensors
Reverse 6 Signal
- 23 -
button (DOWN) for
button
C1 Start
value Sensitivity
05 Standard
06 Lower