Audio Screen; Setting Preset Stations - Chevrolet tahoe 2004 Manual

To scan preset stations, press and hold the SEEK up or
down arrow for more than four seconds. You will hear two
beeps and PSCAN will be displayed, along with the
number preset. The radio will go to the first preset station
stored on your push-buttons, play for a few seconds, then
go on to the next preset station. Press either SEEK arrow
again to stop scanning presets.
The radio will seek and scan only to stations that are in
the selected band and only to those with a strong signal.

Setting Preset Stations

The six multi-function keys, located to the right of the
navigation screen, allow you to store your favorite
stations. You can store up to 30 stations (6 AM, 6 FM1,
6 FM2, 6 XM1, and 6 XM2, if equipped). To set
preset stations, do the following:
1. Turn the audio system on.
2. Press the BAND hard key to select the desired
band (AM, FM1, FM2, XM1 or XM2, if equipped).
3. Locate the desired station using the SEEK hard key
or the joystick.
4. Press and hold one of the six hard keys located to
the right of the navigation screen, until you hear a
beep. Whenever you press that hard key while
in the BAND menu, the station you set will return.
5. Repeat the steps for each preset and source.

Audio Screen

The audio screen will display information on the current
station as well as list the presets for the current band.
FM1 Source Shown, Other Sources Similar
If the radio is on while the navigation system is in use,
a smaller audio screen will appear, located on the
left side of the map screen. This audio screen will
display the current audio information, such as band
and station.
3-3