Summary of Contents for Oakley Sound RM-4014
- Page 1 Oakley Sound Systems 5U Oakley Modular Series RM-4014 Ring Modulator PCB Issue 3 User Manual V3.0.0 Tony Allgood B.Eng PGCE Oakley Sound Systems CARLISLE United Kingdom...
- Page 2 The suggested 5U panel design. Note the slightly different spacing of the knobs compared with the usual 41mm 5U Oakley standard.
- Page 3 Introduction This is the User Manual for the issue 3 RM-4014 Ring Modulator 5U module from Oakley Sound. This document contains an overview of the operation of the unit and the calibration procedure. For the Builder's Guide, which contains a basic introduction to the board, a full parts list for...
- Page 4 X and Y inputs at the same time. Input signals will be summed together so you can also use the RM-4014 as a simple audio mixer. This is the prototype issue 1 RM-4014 Ring Modulator module behind a natural finish 1U wide MOTM format Schaeffer panel.
- Page 5 Calibration There are three trimmers on the PCB which need adjusting correctly to get the best out of the ring modulator module. It is important that you adjust these in your modular as the settings are affected by the power supply voltages. Allow the modular and ring modulator to warm up for 15 minutes.
-
Page 6: Final Comments
I hope you enjoy using the Oakley Ring Modulator module. If you have any problems with the module, an excellent source of support is the Oakley Sound Forum at Muffwiggler.com. Paul Darlow and I are on this group, as well as many other users and builders of Oakley modules.