Table of Contents
Advertisement
Advertisement
Table of Contents
Summary of Contents for Swiss Bionic iMRS One
- Page 1 intelligent Lifestyle Operating Manual Operating Manual...
- Page 2 The iMRS one is a system for use at home. In medical use, it can also play an accompanying and supportive role for a number of conditions.
-
Page 3: Table Of Contents
1. Safety Instructions: Where You should be Careful ........4 1.1 Contra-indications ..................9 1.2 Side Effects ....................9 2. Intended Use ....................10 2.1 Essential Performance Characteristics of the iMRS one ......10 3. Possible Applications ..................10 4. Scope of Delivery ...................11 4.1 Control Unit ....................12 5. -
Page 4: Safety Instructions: Where You Should Be Careful
The accessories listed may only be used together with an Omnium1 control system from Swiss Bionic Solutions Schweiz GmbH. The device may not be operated in combination with other devices, nor be placed in a stack of, or located in the proximity, to such other devices. - Page 5 Guidelines and Manufacturer‘s Declaration: Electromagnetic Interfer- ence Emissions The iMRS one is intended for operation in an ELECTROMAGNETIC ENVIRONMENT as shown below. The customer or user of the iMRS one should ensure that it is operated in such an environment. Interference emission mea-...
- Page 6 If the to IEC 61000-4-11 in Ut) for 5 periods in Ut) for 5 periods iMRS one user requires con- 70 % Ut (30 % 70 % Ut (30 % tinuous operation, even when dip in Ut) for 25...
- Page 7 COMPLIANCE LEVEL mentioned above, the iMRS one should be checked to verify its OPERATION in the man- ner intended. If unusual performance characteristics are observed, additional measures may necessary, such as changing the orientation or choosing a different location for the iMRS one.
- Page 8 (transmitters) and the iMRS one, depending on the output power of the com- munication device as indicated below.
-
Page 9: Contraindications
Electronic implants such as pace makers or insulin pumps (with the exception of approval by the consulting physician) The iMRS one system may only be used with the approval of a health care practi- tioner and under medical supervision under the following conditions: •... -
Page 10: Intended Use
To relax muscles locally. Important notice: The iMRS one is regulated by the FDA as a therapeutic massager (21 CFR 890.5660). However, the iMRS one is not intended to diagnose, treat, cure or prevent any disease. Those seeking treatment for a specific disease should consult a qualified integrative... -
Page 11: Scope Of Delivery
4. Scope of Delivery iMRS one Android software (Pre-installed on the Omnium1) OmniMat OmniSpot OmniPad Not included with the iMRS one basic set D/A Converter 20-pin Cable Operating Manual If one part should be damaged or missing, please contact your consultant at... -
Page 12: Control Unit
4.1 Control Unit The iMRS one will only function in connection with the Omnium1 control unit. The Omnium1 control device is included in the scope of delivery for all iMRS one sets available. You will fi nd the operating instructions for the Omnium1 in one sets available. -
Page 13: Installation
5. Installation 1. Take the individual parts out of the packaging. Place the full-body applica- tor on a stable, even surface, such as on the floor, on a couch or under the mattress (but not box-spring mattresses) of your bed (pay attention to the intensity adjustment, please). -
Page 14: Activation
Om- nium1 desktop (2). Afterwards, the iMRS one initial screen will display the legally indicated cont- raindications. As soon as it has been acknowledged (by pressing ENTER), you will see the user interface for the iMRS one application. -
Page 15: Saving And Loading Pre-Set Parameters
7. 7. Saving and Loading Pre-set Parameters The iMRS one application provides you with the ability to save various users in advance. You can save all organ clocks with all time and intensity levels for each applicator in advance and load them as needed. -
Page 16: Loading
User icon (2). A list of all of the created users will appear. Tap on the desired user and start the application by tap the “Start/Stop” button (3). The iMRS one application will always detect automatically the connected appli- cator and use the pre-set user parameters from internal memory. -
Page 17: Starting An Application
8. Starting an Application Connect the D/A converter and the desired applicator (see Chapter 5, Installa- tion) and start the iMRS one application (see Chapter 6, Activation). After the system has been successfully started, chose the desired application duration. To do so, tap the circle next to Timer and set the desired application dura- tion from 1 to 60 minutes. -
Page 18: Quick Start Programs
From this sub-menu item, you can see the version of the fi rmware & hard- ware, the serial number for the D/A converter (if it is connected), the version of the iMRS one software app as well as the serial number of the Omnium1 unit. -
Page 19: Factory Settings
10.2 Factory Settings By tapping the “Reset Factory Settings” button, you can restore the iMRS one app to its delivery state. Note: all of the stored users will be deleted. 10.3 Users See Chapter 7, Saving and Loading Pre-set Parameters. -
Page 20: Omnipad
12.3 OmniSpot (Not included with the iMRS one basic set) The OmniSpot applicator can be used for isolated applications, for example: a knee, a foot, a hand and so forth. It has been covered with certified artificial... -
Page 21: Cleaning And Maintenance
leather. The material is easy to maintain, can be cleaned and can be rinsed with mild disinfecting agents. Two solid copper coils have been built into the OmniSpot. The magnetic field not only works directly above the OmniSpot applicator, but also spreads itself out in all directions. -
Page 22: Maintenance & Error Message
The OMNIBRAIN system has not been connected, or not been connected properly (optional!). Repairs and service should only be performed by the manufacturer or the respective local offices of Swiss Bionic Solutions (you will find the addresses at: www.swissbionic.com) or from your supporting Certified LifeStyle Consultant. Manufacturer: Swiss Bionic Solutions Schweiz GmbH Bodenackerstr. -
Page 23: Identification & Technical Data
0483 Legacy Electrical Device Act The conformity according to EC directives has been explained for the equipment described in this Operator›s Guide. 15.2. Technical Data for the iMRS one D/A Converter Designation Values, unit, type and model Control Unit Device type... - Page 24 Construction Portable device Protection class Application part Type B Type of moisture protection Covered device Fuse between the primary and sec- Omnium1 Type BI20-180100-I power supply ondary power supplies Initial voltage at the applicator box Max. 20 V direct current Boxes for connection with the Omni- M12, 5-pin Mat, OmniPad and OmniSpot...
-
Page 25: Warranty
65,00 120,00 16. Warranty The iMRS one magnetic resonance stimulation system is the result of inno- vative research and development work. Swiss Bionic Solutions provides the warranty on the applicators and the D/A converter for a period of 36 months from the date of purchase. - Page 28 Swiss Bionic Solutions Schweiz GmbH Bodenackerstrasse 69 | 4657 Dulliken, Schweiz Phone: +41 (62) 295 5951 | Fax: +41 (62) 295 5952 Email: ch@swissbionic.com Swiss Bionic Solutions Deutschland GmbH Am Sandfeld 17a | 76149 Karlsruhe, Deutschland Phone: +49 (721) 464 7180 | Fax: +49 (721) 464 71818 Email: de@swissbionic.com...
Need help?
Do you have a question about the iMRS One and is the answer not in the manual?
Questions and answers