Table of Contents
Advertisement
Device Table
NOTE:
Please refer to Table 1a when in the "PROGRAMMING THE REMOTE USING DEVICE CODES"
section. After programming is complete, the Universal Remote Control will be able to control the
following types of devices:
NOTE:
If Peerless-AV Display is unresponsive to commands being sent, press the TV button and send the
commands again.
Table1a
Programming the Remote using Device Codes
To have universal control of your devices through the Peerless-AV Programmable Remote, perform
the following steps; otherwise skip this section. Fully read and understand the process before
attempting to program the remote.
1.
Turn on the device that you would like to program into your remote using the power button the
the device.
2.
On the Peerless-AV Universal remote control, press and hold the button that you are trying to
program (TV, DVD, CBL, or AUX) and the OK button simultaneously for 2 seconds. The Red
LED on the remote will illuminate.
3.
In the "MANUFACTURER'S CODES" section (page 6), locate the type and brand name of the
device you are trying to program into the remote. Once you have located it, enter the fi rst 3-digit
code for your device. If the device that you are trying to control turns off, press the Device button
that you were trying to program (TV, DVD, CBL, or AUX). The Red LED will blink two times.
4.
To confi rm the code works properly, press the Device button again then press the Power button.
The device should turn on; however, if the device did not turn on, please repeat step 1-3 above
with the next code in the list for that manufacturer.
If none of the listed codes work with your device, proceed to the "PROGRAMMING THE REMOTE BY
SEARCHING FOR CODES" section (page 6).
TV
DVD
CBL
AUX
Controls the Peerless-AV Display
Blu-ray, DVD, DVR, VCR, TV/VCR
Cable Box, Satellite Box
CD, LD, Home Automation, PVR Device
5
2015-10-15
#:180-9068-1
Hide quick links:
Advertisement
Table of Contents
