Miele WT 2780 WPM Quick Start Manual page 7

H Start the programme
^ Press the flashing Start/Stop button.
I Remove the laundry when the
programme has finished.
Take note of the section "After each
washing or drying programme".
,
Make sure that objects e.g.
detergent dispensing balls have
been removed from the laundry.
They could melt and cause damage
to the dryer or the laundry.
Rinse out fluff programme
The fluff which occurs during drying
can collect in the drum and also in the
suds container. It is best to rinse out
this fluff before the machine is used
again so that it cannot be deposited on
the next load (e.g. fluff from dark
garments being deposited on lighter
coloured items) or cause a blockage.
^ Switch on the machine and turn the
programme selector to the Rinse out
fluff programme.
If there is a lot of fluff in the machine,
select the Water plus Extra option.
^ Press the flashing Start/Stop button.
^ Remove any fluff remaining from
around the door seal and porthole
glass.
Washing and drying without
interruption
^ Press Washing/Drying button
repeatedly until Washing and Drying
indicator lights are lit up.
D Select wash temperature, spin
speed and drying level
^ Change these settings with X or Y
and confirm with OK .
E Selecting Extra options
^ Select Extra options, Stains, Low
temperature.
F Load the washer-dryer
^ Open the door and put the laundry in
the drum.
^ Take note of the load size indicator.
G Shut the door
Make sure that no garments are
caught between the drum door and
seal.
H Add detergent
^ Observe the recommended amount
of detergent.
I Switch on Delay start
J Start the programme
^ Press the flashing Start/Stop button.
K Remove the laundry when the
programme has finished.
Take note of the section "After each
washing or drying programme".