Related Manuals for C-KO CT Series
Summary of Contents for C-KO CT Series
- Page 1 C-KO CT range DVR Version 1: August 2015 Quick start guide for CT range DVRs Please read this guide carefully before installation.
-
Page 2: Table Of Contents
Table of Contents Wiring Diagram ....................3 HDD Installation ....................4 Setting up the Time ................... 6 Entering Vehicle Information ................7 Video Resolution Setup ..................7 Setting up the Triggers ..................9 Page 2 of 10... -
Page 3: Wiring Diagram
Wiring Diagram Page 3 of 10... -
Page 4: Hdd Installation
HDD Installation Page 4 of 10... - Page 5 Once the unit is powered up the DVR will automatically format a brand new HDD. This process may take up to 10 minutes depending on the size of the HDD. Once the format is complete the red dot recording lights will appear on screen, please refer to the image below.
-
Page 6: Setting Up The Time
Setting up the Time While the HDD is formatting you can change the settings for the DVR setup, first is the time and date. First press the ‘LOGIN’ button on the remote, and then enter the password. (By default it is set to ‘111111’) Once into the time set menu change the ‘TIME ZONE’... -
Page 7: Entering Vehicle Information
Entering Vehicle Information Next step is to enter the registration of the vehicle this information is then stamped onto any recorded footage. Under the license tab enter the vehicle registration number; you could also enter the company name under company. Video Resolution Setup There are three different resolutions the DVR can record at, these are: ... - Page 8 First change the resolution to the required level, highlight the relevant field and use the + and – buttons on the remote to change the value. Next change the recording level, where 1 is the highest and 8 is the lowest. Once again highlight the field and use the + and –...
-
Page 9: Setting Up The Triggers
Last setting on this page is only required if you plan on recording audio. All you need to do is turn audio on, on the relevant channel/s. Once all the required settings have been changed remember to hit save at the bottom of the page. - Page 10 IN5 – Set to BRAKE Please refer to the image below as a guide, these inputs allow the playback software to show if the driver was indicating, braking or reversing at any point. The DVR also has the ability to trigger a curtain camera full screen. The main two to trigger are the near side and back cameras.