Table of Contents
Advertisement
Use and Care Information
Operations:
•
Read and understand all instructions and warnings in this manual before operating the appliance. Save these
instructions for future reference.
•
Always leave safety grills and filters in place. Without these components, operating blowers could catch on to
hair, fingers and loose clothing.
•
NEVER dispose cigarette ashes, ignitable substances, or any foreign objects into blowers.
•
NEVER leave cooking unattended. When frying, oil in the pan can easily overheat and catch fire. The risk of
self combustion is higher when the oil has been used several times.
•
NEVER cook on "open" flames under the range hood. Check deep-fryers during use: Superheated oil may be
flammable.
Cleaning:
•
The saturation of greasy residue in the blower and filters may cause increased inflammability. Keep unit clean
and free of grease and residue build-up at all times to prevent possible fires.
•
Filters must be cleaned periodically and free from accumulation of cooking residue (see cleaning instructions
on Page 22). Old and worn filters must be replaced immediately.
•
Do not operate blowers when filters are removed. Never disassemble parts to clean without proper instruc-
tions. Disassembly is recommended to be performed by qualified personnel only. Read and understand all
instructions and warnings in this manual before proceeding.
Specifications
Body
Power Rating
General Input Power
Motor Input Power
Motor Revolution
Levels Of Speed Control
Airflow (CFM)
Air Pressure
Noise Level (Sone)
Motor Type
Fan Type
Control Type
Filtration Type
Illumination
Venting Size
Interference Protection
* Subject to change without notice, please contact your local reseller for details.
Specifications
:
*
Stainless Steel / Tempered Glass
120V/60Hz (USA & Canada standard)
120W(Motor) + 2 x 20W (Lights)= 160W
120 W
600 RPM (±10%) to 1400 RPM (±10%)
3 Levels
600 CFM on max speed (200 / 400 / 600CFM)
120 Pa (170 Pa Maximum)
Approximately 0.8 to 6.5 (Lowest to highest Speed)
Single Chamber Ultra Quiet
Centrifugal / Sirocco
3 Spd Mechinical , 3 speed electronic
Aluminum Filters
20W(J4) 12V / LED 12V / 35W(GU10) 110V.
Top, 6 inches Round
Radio Frequency Interference Protected
Maintenance
SAFETY WARNING: Never put your hand into area housing the
fan while the fan is operating!
For optimal operation, clean range hood & all filter/oil container regu-
larly. Regular care will help preserve the range hood's performance &
appearance.
Cleaning Exterior Surfaces:
•
Clean periodically with hot soapy water and clean cotton cloth. Do not use corrosive or abrasive detergent (e.g. Comet
Power Scruv
, EZ-Off
®
surface. For heavier soil use liquid degrease such as "Forumla 409
•
If hood looks splotchy (stainless steel hood), use a stainless steel cleaner to clean the surface of the hood. Avoid getting
cleaning solution onto or into the control panel. Follow directions of the stainless steel cleaner. CAUTION: Do not
leave on too long as this may cause damage to hood finish. Use soft towel to wipe off the cleaning solution, gently
rub off any stubborn spots. Use dry soft towel to dry the hood.
•
After cleaning, you may use non abrasive stainless steel polish such as 3M
luster and grain. Always scrub lightly, with clean cotton cloth, and with the grain.
•
DO NOT allow deposits to accumulate or remain on the hood.
•
DO NOT use ordinary steel wool or steel brushes. Small bits of steel may adhere to the surface and cause rusting.
•
DO NOT allow salt solutions, disinfectants, bleaches, or cleaning compounds to remain in contact with stainless steel
for extended periods. Many of these compounds contain chemicals, which may be harmful. Rinse with water after ex-
posure and wipe dry with a clean cloth.
Cleaning Aluminum Grease Filter / Stainless Steel Filterless Grill:
•
The aluminum filters fitted by the factory are intended to filter out residue and grease from cooking. It need not be
replaced on a regular basis but are required to be kept clean. Filters should be cleaned after every 30-50 hours of use.
•
Remove and clean by hand or dishwasher ( set the dishwasher water temperature to LOW and DO NOT USE DRY
CYCLE, or the high temperature could damage and discolour the filters).
•
IMPORTANT: Drain oil from oil containers before oil and residue overflow!
Replacing Filters:
•
Should filters wear out due to age and prolonged use, replace with following part number: SV400-ACS-AF/SF
•
Note: Also replace damaged filter that has punctured or broken mesh, bent or broken frame.
Replacing J4 Type Halogen Light Fixture:
•
This range hood uses halogen light fixture: 20W 12V (Product ID: SV-ACS-HAL20W).
•
Make sure the range hood is unplugged or turn OFF breaker and the lights are cool to touch.
•
Place a flat-head screwdriver between light housing and hood body, gently pry up the light housing and search for the
metal clip.
•
Apply force to the metal clip and pull out the light fixture. Disconnect the power cable and discard the old light fix-
ture.
•
Reverse the steps to install a new halogen light fixture. Turn ON breaker and range hood to test for operation.
Page 16
Light bulb become extremely hot when turned on.
DO NOT touch bulb until switched off and cooled.
Touching hot bulbs could cause serious burns.
oven cleaner), or steel wool/scoring pads, which will scratch and damage the stainless steel
®
" or "Fantastic
®
WARNING
Hazard of Burns!
" brand cleaner.
®
®
or ZEP
®
, to polish and buff out the stainless
Page 17
Advertisement
Table of Contents
