ACDelco I-7002 Owner's Manual page 2

SAVE THESE INSTRUCTIONS.
For your safety, read, understand, and follow
the information provided with and on this
battery charger. The owner and operator of
this equipment shall have an understanding
of this product and safe operating procedures
before attempting to use. The owner and
operator shall be aware that use and repair of
this product may require special skills and
knowledge. Instructions and safety information
shall be conveyed in the operator's native
language before use of this product is
authorized. If any doubt exists as to the safe
and proper use of this battery charger, remove
from service immediately.
INSPECT BEFORE EACH USE. Do not use
if broken, bent, cracked, melted or otherwise
damaged parts (including labels) are noted.
Any battery charger that appears damaged in
any way, operates abnormally or is missing
parts, shall be removed from service
immediately. If the battery charger has been
or suspected to have been dropped, subjected
to rain or snow, or immersed in liquid, !STOP!
and immediately discontinue use until
battery charger has been checked by a factory
authorized service center. It is recommended
that an annual inspection be done by qualified
personnel. Labels and Owner's Manuals are
available from manufacturer.
Cord Storage (back panel)
Display
& LED
Indicators
Battery Charger Nomenclature
(see pg. 7 for control panel detail)
PRODUCT DESCRIPTION
Automatic battery charger is designed to
charge 12 Volt, rechargeable lead acid
batteries with rated Amp Hour (Ah) capacity
of no less than 12Ah. The application can be
applied on conventional automotive,
maintenance free, marine deep cycle and
AGM, Gel cell batteries such as those used in
cars, trucks, farm equipment, boats, lawn
mowers, tractors, airplanes, motorcycles,
vans, RVs and SUVs, personal watercraft,
snowmobiles, ATVs, trolling motors, etc.
It is designed to be indoor use and for
occasional outdoor use. NEVER expose this
device to rain, snow, fog, or high humidity.
This charger is equipped with 5 charge rate
settings: 2, 6, 10, 12, and 15A.
It is microprocessor controlled to provide ease
of use.
Lighted, digital display shows charging
voltage, charging current, % Charge, Error
Codes and Operation Mode. Charge rate
settings of 2,6,10,12,15A, PLUS a special
Maintenance mode which sends a controlled
pulse which helps slow down the effects of
plate sulfated.
Carry Handle
2
Control
Panel