Primera PASSPORT V2 Operating Instructions

PASSPORT (V2)
The Primera PASSPORT Access Control System operates on a shadow card system.
The system uses 5 different types of cards:
1) Programming Card (Navy Blue)
2) System Restore Card (Red)
3) Passage Set Card (Green)
4) User Cards (Light Blue)
User Cards can be substituted with Fobs or Wristbands.
5) Shadow Cards (Grey)
To avoid confusion when programming the PASSPORT system with existing cards, please ensure all cards are clearly identified and
marked.
Each lock has a maximum capacity of 70 Users.
In an environment where there are multiple PASSPORT systems it is recommended that each unit is programmed using the same
control cards (Programming, System Restore & Passage Set). All cards can be used to control or operate as many PASSPORT
locks as are required. Each User Card must have a Shadow Card (for deletion purposes).
Initialising the Programming Card: From the factory each PASSPORT system is
delivered so that when batteries are installed a red LED will indicate a readiness
to receive the Programming Card (See Fig.1). The first card presented to the
reader will be registered as the Programming Card regardless of its markings.
This will be confirmed by an audible tone of 3 bleeps and both red and amber
LED's will illuminate in preparation for receiving the System Restore Card (See
Fig.2).
Note: Under normal operating conditions the Programming Card puts the system in
to the learn mode which is signalled by a continuous Red LED (See Fig.1). Only
during the initialisation procedure will the red and amber LED illuminate in
preparation for programming the System Restore Card (See Fig.2). Programming
sessions are closed using the Programming Card again which extinguishes all
LED's leaving the system in the user mode (See Fig.4).
Initialising the System Restore Card: Following the procedure detailed above and
with both red and amber LED's illuminated, the next card presented to the reader
regardless of its markings will be registered as the System Restore Card (See
Fig.2). This is confirmed by an audible tone of 3 bleeps after which all LED's (red,
amber & green) are illuminated (See Fig.3) in readiness for learning on the
Passage Set Card. When both the Programming and System Restore Cards have
been learned on to the system, the lock is now ready to be programmed with the
Passage Set Card.
Warning: The System Restore Card should be kept secure. It should be used with
caution and only when there is a need to fully erase the lock memory for complete
re-programming.
Initialising the Passage Set Card: With all LED's (red, amber, green) illuminated, the
next card presented to the reader regardless of its markings, will be registered as
the Passage Set Card. This is confirmed by 3 +1 rapid bleeps, after which all the
LED's will be extinguished (See Fig 4). The Passage Set Card is used to unlock
the door for indefinite periods.
Programming & Operating Instructions Shown Overleaf...
Initialising the Control Cards
1
(Fig 1) Red LED
(Fig 2) Red and
amber LED's
(Fig 3) Both red
and amber LED's
(Fig 4) No LED's