Monster Power PowerCenter HTS 2600 MKII Owner's Manual page 22

Symptom
The PowerCenter is
not receiving power.
16
TROUBLESHOOTING
Possible Cause
The PowerCenter
is not turned On.
Too many devices are
connected, causing an
overload, tripping the
Thermal Circuit Breaker.
Remedy
• Turn the PowerCenter switch on.
• Make sure the PowerCenter's AC power plug
is plugged into a properly grounded
120 volts (nominal) wall outlet.
• In some households, a wall switch may need
to be thrown to make the wall plug active.
Try turning on the light switches located
near the wall unit.
• Press the PowerCenter Thermal Circuit
Breaker button in to reset. Please allow
10 minutes before attempting to reset.
If you reset too soon, the breaker will
prematurely sense power overload and
not allow unit to operate.
• If the Circuit Breaker continues to trip,
try moving one or more components
to another PowerCenter. You may be drawing
too much current through one PowerCenter.