GE 2-9920 User Manual page 13

Problem
Cannot hear the
Page alert tone
Range is shorter
than normal
Battery will not hold a
charge or is fully charged
and the BAT LOW lights
BAT LOW light stays on
Memory Dialing
doesn't work
Unit locks up
Solution
• Set the RING/PWR switch on the handset to ON (the far left
position).
• Press the CHAN button during the conversation to select a
new channel.
• Position the base antenna upward.
• Be sure you are sufficiently charging the battery. When the
battery has been charged for 12 hours, you can expect
approximately 4 hours of talk time.
• Check to be sure battery contacts on both the handset and
the base are making contact and are clean; free of dirt or lint.
• When the handset is placed in the base, check that the base
CHARGE light is on.
• Place handset in base for 10 seconds to reset the phone. If
that doesn't work, charge battery for 12 hours.
• Did you program the memory location keys correctly?
See p. 8.
• Did you follow proper dialing sequence? See p. 10.
• Make sure T/P switch is correctly set.
(see Installation sections, pp. 3-4).
• If the unit doesn't work, turn the power switch on the handset
off. Hold down digit 2 and 8 simultaneously and then turn the
power switch on. Put the handset back on the base and press
the PAGE button until you hear a beep.
• If a power outage occurs while the handset is away from the
base, the handset must be returned to the base when the
13