Operation - LENCO SVB Owner's Manual

Switch Operation
SWITCH OPERATION
The operation of all Lenco switches is
based on the position of the bow. To
lower the starboard bow, press the right
(starboard) side of the switch where it
reads Down. This lowers the port tab. To
lower the port bow, press the left (port)
side of the switch where it reads Down.
This lowers the starboard tab.
Indicator switch (123sC) with self
Check Feature
On the Indicator switch, the L.E.D. lights
on the sides of the display show how
far that tab has moved. When the on/
off switch is turned on at the helm or the
engine's tachometer circuit becomes
active, the L.E.D. displays on the
indicator switch light from top to bottom
and immediately extinguish from bottom
to top to indicate self test at power up.
If there is a problem with an actuator
connection the L.E.D. displays shows
every other red light "ON" at the side
that has the problem (see Fig.1). After self
To lower the
port bow
Standard Switch
#15069-001(124SSR)
Fig. 1
9
To lower the
starboard bow
test is complete (1 to 2 seconds) the L.E.D.
displays show one up arrow on each side
of the switch. This shows that both tabs are
fully retracted. While operating the tabs,
the L.E.D. displays indicate the position of
the tabs by lighting up the further they are
pressed down. As the switch is pressed up,
the lights go out. When power is removed
from the switch, the tabs retract from any
position before powering down (See page 8
for more information).
Dual ram Indicator switch (123Dr)
At start up the L.E.D. displays show one
up arrow on each side of the switch. This
shows that both tabs are functioning and
are fully retracted. While operating the tabs,
the L.E.D. displays indicate the position of
the tabs by lighting up the further they are
pressed down. As the switch is pressed up,
the lights go out. When power is removed
from the switch, the tabs retract from any
position before powering down (See page 8
for more information).
nOTe: There is no self check mode
for the Dual ram Indicator switch
Part # 15071-001.
Indicator Switch with Retractor
#15070-001(123SC)
#15071-001(123DR)
LENCO MARINE