Vax VCC-05 User Manual page 9

FAQ's
WARNING: To reduce the risk of personal injury, unplug the vacuum cleaner before performing
maintenance/troubleshooting checks.
Problem
Cleaner won't run
Cleaner won't pick up/loss
of suction
Accessories won't pick up
Dust escaping from the
vacuum cleaner
505
vax.com.au
900
Cause
Not properly plugged into electrical outlet.
Vacuum cleaner not turned on.
No electricity in the electrical outlet.
Blown fuse/tripped breaker.
Motor thermostat has tripped.
Dust bag not installed correctly.
Dust bag full or blocked.
Clogged filter.
Blockage in hose.
Accessories are not attached correctly.
Dust bag full.
Dust bag not installed correctly.
Hose is not installed correctly.
Filter not installed completely.
Solution
Plug unit in firmly.
Press on/off button.
Check fuse or breaker.
Reset circuit breaker or replace fuse.
Switch off and unplug the vacuum cleaner.
Leave for one (1) hour. See page 3.
Review dust bag removal and replacement.
Replace dust bag. Empty/clean/replace
cloth bag
Remove/replace with new filter VCC-05.
Remove wash/replace HEPA filter VCC-07.
Disconnect hose, remove the obstruction
then re-fit.
Refer to page 4 for fitting information.
Dispose of paper dust bag, replace with a new
one or empty/clean/replace cloth bag.
Review dust bag removal and replacement.
Review hose installation.
Review filter removal and replacement.
8