Table of Contents
Advertisement
OPERATING INSTRUCTIONS
A. This appliance is equipped with an ignition device which automatically lights the pilot. Do not try to light the
unit by hand.
B. BEFORE OPERATING smell all around the appliance area for gas. Be sure to smell next to the floor because
some gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS:
•
Do not attempt to light any appliance.
•
Do not touch any electric switch; do not use any phone in your building.
•
Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's instructions.
•
If you cannot reach your gas supplier, call the fire department.
C. Use only your hand to push in, or turn the gas control knob. Never use tools. If the knob will not push in or turn
by hand, don't try to repair it. Call a qualified service technician. Force or attempted repair may result in a fire
or explosion.
D. Do not use this appliance if any part of it has been under water. Immediately call a qualified service technician
to inspect the appliance and to replace any part of the control system and any gas control that has been under
water.
Piezo Ignitor
Control Knob
Figure 28 - Location of Piezo Ignitor and Control
Knob on Manual and Thermostat Unit
26
FOR YOUR SAFETY READ BEFORE LIGHTING
If you do not follow these instruction
exactly, a fire or explosion may result
causing property damage, personal
injury or loss of life.
Hi/Low Knob
Control Knob
On/Off Switch
Figure 29 - Location of Piezo Ignitor, On/Off
Switch, and Control Knob on Milli-Volt Unit
Piezo Ignitor
14D2099
Hide quick links:
Advertisement
Table of Contents
