Assembly Instructions - Nitrofit Deluxe Plus Instruction Manual

Assembly Instructions

8
NOTE:
Please make sure you have all washers, screws
and bolts before assembling your system.
1. Place the Post (9) onto the Base Unit (11). Note: The
vibration absorber (10) has been pre-attached in the
base for you by the factory. Connect the Base Unit Wire
Connector (A) to the Post Bottom Wire Connector (B).
Affix the Post to the Base Unit, secure it with Flat
Washers (8), Spring washers
(7) and Bolts (6) provided.
See Figure 1.
2. Place the Right Handle Bar (2) near the Post (9).
Connect the Right Handle Wire Connector (L) to the
Post Side Wire Connector (G). Align the Right Handle
Bar (2) to the Post and fasten with Flat Washers (8),
Spring Washers (7), and Bolts (6). Place the Left Handle
Bar (3) near the Post (9). Connect the Left Handle Wire
Connector (K) to the Post Side Wire Connector (F).
Align the Left Handle Bar (3) to the Post and fasten
with Flat Washers (8), Spring Washers (7), and Bolts (6).
Note: K,F and G,L may be pre-assembled and coiled
in the left(3) and right(2) Handle Bars. If so, run
connector wires from each handlebar into the holes on
either side of the post (9). Then pull wires up through
the top of the post(9)
See Figure 2.
- 8 -
Fig.1
Fig.2
Fig.3
Copyright © 2015 by Medvibe