Lighting Instructions - UTICA BOILERS USC SERIES Installation, Operation & Maintenance Manual

IF YOU DO NOT FOLLOW THESE INSTRUC-
!
TIONS EXACTLY, A FIRE OR EXPLOSION MAY
RESULT CAUSING PROPERTY DAMAGE, PER-
SONAL INJURY OR LOSS OF LIFE.
1.
This appliance is equipped with an ignition device which
automatically lights the pilot. Do not try to light the pilot
by hand.
2. BEFORE OPERATING smell all around the appliance
area for gas. Be sure to smell next to the floor because
some gas is heavier than air and will settle on the floor.
WHAT TO DO IF yOU SmELL GAS
• Do not try to light any appliance.
• Do not touch any electrical switch
D • o not use any phone in your building.
• Immediately call your gas supplier from a neighbor's
phone.
• Follow the gas supplier's instructions.
• If you cannot reach your gas supplier, call the fire
department.

LIGHTING INSTRUCTIONS

FOR BOILER WITH A HOT SURFACE PILOT SySTEm
WARNING
FOR yOUR SAFETy, READ BEFORE OPERATING!
Before operating, make certain the boiler and system
are full of water to minimum pressure (this is usu-
!
ally 12 lbs. per square inch on most systems) and
system is vented of air. See the operating and lighting
instructions.
3. Use only your hand to move the system control switch.
Never use tools. If the switch will not move by hand, don't
try to repair it, call a qualified service technician. Force or
attempted repair may result in a fire or explosion.
!
Force or attempted repair may result in a fire or ex-
plosion.
4.
Do not use this appliance if any part has been under water.
Immediately call a qualified service technician to inspect the
appliance and to replace any part of the control system and
any gas control which has been under water.
13
CAUTION
WARNING