Instruction Manual Built-in Gas Hob Model Domino-302 www.fontron.com NOTE: This User Instruction Manual contains important information, including safety & installation points, which will enable you to get the most out of your appliance. Please keep it in a safe place so that it is easily available for future reference; for you or any...
Contents 1. Close-up View..................03 2. How To Use Your Appliance..............03 3. How to Keep Your Cooktop in Shape..........04 4. Practical Advice..................05 5. Is there a problem?................06 6. Installation Instructions for built-in...........07 7. Table1 Burners and Nozzle Specifications ........11 8. Table2 How to convert gas source............12 9.
Congratulations on choosing appliance, which you will find is dependable and easy to use. We recommend that you read this manual for best performance and to extend the life of your appliance. Thank you. Close-up View 1. Auxiliary Burners 2. Semi-rapid burner 3.
To turn on one of the burners , place a lighted match or lighter near the burner, press the knob all the way in and turn in the counter-clockwise direction to the "High" setting. On those models fitted with a safety device (F) , the knob must be pressed in for about 6 seconds until the device that keeps the flame lighted warms up.
Fig.1 Fig.2 When cleaning the grill, it is recommended that you do so while it is still hot, using the handles provided ● to move it from the cooktop to the sink. To remove the pan beneath the grill, it is a good idea to wait until the heating element has cooled (roughly after 15 minutes) Greasing the Gas Valves Over time, the gas valves may stick or become difficult to turn.
All types of casseroles can be used on the ceramic glass cooking surface. However, it is important that ● the bottom be perfectly flat. Casseroles with thicker bottoms distribute heat more evenly. Use cookware the diameter of which is at least as large as the cooking area so that all of the heat produced by the heating element is used.
Tile minimum has been adjusted correctly (see the section entitled, "Minimum Regulation"). ● The cookware is not stable. Check to make sure that: The bottom of the cookware is perfectly flat. ● The cookware is centered correctly on the burner or electric hot plate. ●...
Page 9
Examples of ventilation holes for comburant air. Enlarging the ventilation slot between window and floor Fig.3 Fig.4 c) Intensive and prolonged use of the appliance may necessitate supplemental ventilation, e.g. opening a Window or increasing the power of the air intake system (if present). d) Liquidified petroleum gases are heavier than air and, as a result, settle downwards.
Page 10
Fig.6 Hook position for Hook position for Hook position for H=30mm top H=40mm top H=20mm top N.B: Use the hook contained in the "accessories set"...
Page 11
f) In the event the cooktop is not installed above a built-in oven, a wood panel must be inserted as insulation. This panel must be placed at least 20 mm from the bottom of the cooktop itself. lmportant: When installing the hob above a built-in oven, the oven should be placed on two wooden strips;...
Page 12
Once the appliance has been installed, make sure all the connections are properly sealed, using a soapy water solution. Never use a flame. Electrical Connection The cooktops fitted with a tripolar electrical supply cord are designed to be used with alternating current according to the indications on the rating plate located under the cooktop.
Page 13
Triple Ring 3.40 3.40 3.40 3.40 3.40 (TR) Supply 20mbar 25mbar 20mbar 13mbar mbar mbar mbar Mbar pressures At 15°C and 1013 mbar-dry gas P.C.I.G20 37.78 MJ/m³ P.C.I.G25.1 32.51 MJ/m³ P.C.I.G25 32.49 MJ/m³ P.C.I.G27 30.98 MJ/m³ P.C.I.G2.350 27.20MJ/ m³ P.C.I.G30 49.47MJ/Kg Replacement of burner nozzle: loosen the nozzle with a dedicated wrench (7).Fit the new nozzle, suitable for the required gas type (see table above for...
Page 14
Fig.7 Checking the adjusted flame: heat the burner at full open position for 10 minutes. The turn the knob into the saving setting. The flame should not extinguish nor move to the nozzle. If it goes off or moves over to the nozzle, readjust the valves.
NOTICE: A.”prior to installation,ensure that the local distribution condition (nature of the gas pressure) And the adjustment of the appliance are compatible.” B. “The adjustment conditions for this appliance are stated on the label.” C. “This appliance is not connected to combustion products evacuation device. It shall be installed and connected in accordance with current installation regulations.
Need help?
Do you have a question about the Domino-302 and is the answer not in the manual?
Questions and answers