Shimano CM-1000 Basic Operation

1. BEFORE POWERING UP YOUR SHIMANO SPORT CAMERA:
A continuous "beeb" will sound and red light flash on the LED display if card
2. POWERING UP YOUR SHIMANO SPORT CAMERA:
When the camera is first powered up the LED lights will indicate battery levels (left)
and available space left on memory card (right). See below.
FLASHING GREEN LIGHT = CHARGING
FLASHING
CM-1000 BASIC OPERATION
not installed correctly on start up.
Estimated SD Card storage (4GB demonstrated)
Unlock and open the back cover, using the
USB cable included connect to power source
and completely charge the unit, insert a Micro
SD/SDHC card (not shipped with camera),
close hatch and ensure the lock/unlock
switch is returned to the lock position.
** Micro SD/SDHC Card - Class 6 or higher
and maximum of 32gb capacity.
There are two ways to power up your
Shimano Sport Camera.
1) Press and hold the MODE button until two-
beeps sound - this puts the unit on "stand
by" for further user input i.e. setting up WIFI,
selecting shooting modes and recording.
2) Press and hold the RECORD button for 1
second - this will power up the unit directly in
to RECORD mode.
FLASHING