Sony Alpha A7s2 Instruction Manual page 4

This equipmenl complies with FCC/IC
radiation exposure limits sci forth for an
uncontrolled environment and meets [he
FCC radio frequency (RF) Exposure
Guidelines and RSS-102 of the IC radio
frequency (RF) Exposure rules. This
equipment has very low levels of RF
energy that are deemed to comply without
testing of specific absorption ratio (SAR).
'for Cu!IOmers in the O_.s.��
If you have any questions about this
product, you may call:
Sony Customer Information Center
1-800-222-SONY (7669).
The number below is for the FCC related
matters only.
Regulatory Information
Trade Name: SONY
Declaration of Conformity
Model No .. WW898259
Responsible Party: Sony Electronics Inc.
Address: 16535 Via Esprillo,
San Diego. CA 92127 U.S.A.
Telephone No.: 858-942-2230
This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two condilions: (I) This
device may not cause harmful
in1erference, and (2) this device must
accept any interference received.
including interference that may cause
undesired operation.
This equipment must not be co.Jocated or
opcr.ited in conjunction wi1h any olher
antenna or transmiller.
You are cautioned that any changes or
CAUTION
modifications not expressly approved in
this manual could void your authority lO
operate this equipment.
GB
4
This equipmenl has been tested and found
Note:
to comply wi1h the limits for a Class B
digital device, pursuant to Part 15 of the
FCC Rules.
These limits arc designed to provide
reasonable protection ag.iinst harmful
interference in a residential installation.
This equipment generates. uses. and can
radiate radio frequency energy and, if not
installed and used in .: u .:i:ordance with 1he
inslructions. may cause harmful
interference to radio communications.
However. there is no guarantee that
inlerference will not occur in a particular
installation. If this equipment does cause
harmful interference to radio or television
reception, which can be dch. :: rmined by
turning the equipment off and on, the user
is encouraged to try to correct the
interference by one or more of the
following measures:
- Reorient or relocate the receiving
antenna.
- Increase the separation between the
equipment and receiver.
- Connect the equipmcnl inlo an outlet on a
circuit different from that to which the
receiver is connected.
- Consult the dealer or an experienced
radiorrv technician for help.
ll1e supplied intcrf;. 1 ce c;.ible must be used
with the equipment in order to comply with
the limits for a digital device pursuanl to
Subpart B of Part IS of FCC Rules.