Advertisement
Quick Links
18 GAUGE 1-1/4 INCH BRAD NAILER
CALIFORNIA PROPOSITION 65
WARNING: You can create dust
when you cut, sand, drill or grind
materials such as wood, paint,
metal, concrete, cement, or other
masonry. This dust often
contains chemicals known to
cause cancer, birth defects, or
other reproductive harm. Wear
protective gear.
WARNING: This product or its
power cord may contain
chemicals, including lead,
known to the State of California
to cause cancer and birth
defects or other reproductive
harm. Wash hands after
handling.
Important!
When using equipment, a few
safety precautions must be
observed to avoid injuries and
damage. Please read the complete
operating manual with due care.
Keep this manual in a safe place,
so that the information is available
at all times. If you give the
equipment to any other person,
give them these operating
instructions as well. We accept no
liability for damage or
For customer service, call 1-800-348-5004 or email feedback@natitools.com
accidents which arise due to
non-observance of these
instructions and the safety
information herein.
SPECIFICATIONS
Operation Pressure:
60-100 PSI
Magazine Capacity: 100 Piece
Fastener Length: 3/8 - 1-1/4 in.
Nail Size: 18 Gauge
Air Inlet: 1/4" NPT
Air Consumption: 1.6 CFM
CAUTION:
FOR YOUR OWN SAFETY,
READ INSTRUCTION MANUAL
COMPLETELY AND
CAREFULLY BEFORE
OPERATING THIS BRAD
NAILER.
Any failures made in following
the safety regulations and
instructions may result in an
electric shock, fire, and/or
serious injury.
Model: 7552
SAFETY INSTRUCTIONS
1) Read and understand tool
labels and the manual. Failure
to follow warnings, dangers, and
precautions could result in
death or serious injury.
2) Keep work area clean.
Cluttered areas invite injuries.
3) Don't allow children at the
work area. Do not let them
handle the tool.
4) Do not operate the tool if
under the influence of alcohol or
drugs. Read warning labels on
prescriptions to determine if
your judgment or reflexes are
impaired while taking drugs. If
there is any doubt, do not
attempt to operate.
5) Use safety glasses. Safety
glasses should conform to ANSI
Z87.1 specifications. Before
operating, wear safety glasses
against flying debris from the
front and side. Safety glasses
should be worn when loading,
operating, unloading, or
servicing this tool.
6) Use ear protection. The
working area may be exposed
to high noise levels that can
lead to hearing damaged.
8807552
01/13
Advertisement
Summary of Contents for Professional Woodworker 7552
-
Page 1: Safety Instructions
18 GAUGE 1-1/4 INCH BRAD NAILER Model: 7552 accidents which arise due to SAFETY INSTRUCTIONS CALIFORNIA PROPOSITION 65 non-observance of these 1) Read and understand tool WARNING: You can create dust instructions and the safety labels and the manual. Failure when you cut, sand, drill or grind information herein. -
Page 2: Connecting The Tool To An Air Supply
7) Never use oxygen 16) Pay attention to the air hose SETTING combustible gases, bottled and their connections. Don’t trip Your air tool is fully assembled gases or high pressure over hoses. Make sure all when you receive it. Before compressed gas as a power connections are tight. -
Page 3: Loading The Fasteners
2) Turn the compressor on and 3) Hold the body and press the 3) Dirt and water in the air set the regulator to the proper drive guide to the work surface. supply are major causes of pressure for the size and type of Be sure the tool is straight and pneumatic tool wear. - Page 4 Symptom Possible Cause(s) Corrective Action O-Ring in trigger valve are damaged. Check and replace O-Ring Check and replace trigger valve Air leaking at Trigger Trigger Valve head are damaged. head. Trigger Valve stem, seal, or O-Ring are Check and replace trigger valve damaged.
- Page 5 North American Tool Industries (NATI) makes every effort to ensure that this product meets high quality and durability standards. NAT warrants to the original retail consumer a 1-year limited warranty from the date the product was purchased at retail and each product is free from defects in materials. Warranty does not apply to defects due directly or indirectly to misuse, abuse, negligence, or accidents, repairs or alterations, or a lack of maintenance.
- Page 6 18 GAUGE 1-1/4 INCH BRAD NAILER Model: 7552 For customer service, call 1-800-348-5004 or email feedback@natitools.com 8907552 01/13...
- Page 7 Description Description Description Screw Spring Drive Guide Bushing Safe Bracket A Rail Safe Bracket B Spring Pin Exhaust Cover Seal Safe Bracket C Movable Magazine Screw Spring Pin Spring Cylinder Cap Seal Gasket Trigger Valve Head Lock Seal Spring Locking Washer Spring O Ring 5.5x1.5 Feeder Shoe...