Do you have a question about the ZX7-250 SERIES and is the answer not in the manual?
Questions and answers
Summary of Contents for HUAYUAN ELETRIC ZX7-250 SERIES
Page 1
ZX7-MA operator’s manual ZX7-250、315、400MA SERIES MA INVERTER DC ARC WELDING MACHINE OPERATOR’S MANUAL (PLEASE READ CAREFELLY BEFORE OPERATION). CHENGDU HUAYUAN ELETRIC EQUIPMENT CO., LTD. - 1 -...
Page 2
ZX7-MA operator’s manual Safety Depends on You Huayuan arc welding and cutting equipment is designed and built with safety in mind. However, your overall safety can be increased by proper installation ... and thoughtful operation on your part. DO NOT INSTALL, OPERATE OR REPAIR THIS EQUIPMENT WITHOUT READING THIS MANUAL AND THE SAFETY PRECAUTIONS CONTAINED THROUGHOUT.
Page 3
ZX7-MA operator’s manual a. Remove fire hazards from the welding area. If this is not possible, cover them to prevent the welding sparks from starting a fire. Remember that welding sparks and hot materials from welding can easily go through small cracks and openings to adjacent areas.
ZX7-MA operator’s manual 1. Characteristics 1.1General Description ZX7–MA Series MA inverter AC arc welding machines can use all types of welding electrode, especially suitable for low-hydraulic electrode to weld carbon steel and mid-carbon steel. , which is mainly used in electric power build, chemical industry, oil field construction, etc.
ZX7-MA operator’s manual 2.2.3Around working location, dust, corrosive gas and materials don’t exceed the normal content. 2.2.4Should be used in the place where the sea level is less than 1000m. 2.2.5 Wind speed must be less than 1m/s at working location 2.2.6Keep in dry and ventilation, avoid directly sunshine and rain.
Page 7
ZX7-MA operator’s manual 4.2 Electric theory block diagram Input High Inverter rectified Filter 3~380V Output frequency frequency circuit Choke rectifier transformer Pulsed Losing voltage, Auxiliary Amplifying driving over heat circuit transfor circuit short load circuits Arc force Givin circuit circuit Figure 1.
ZX7-MA operator’s manual 8. Troubleshooting & Repair TROUBLE (SYMPTOMS) CAUSE WHAT TO DO 1.welder turn on power, 1.Three phase rectifier was damaged 1. change the rectifier; the power switch trips 2.the capacitor which parallel the 2.change the damaged capacitor. three phase rectifier was damaged. 2 .no output current 1.
Need help?
Do you have a question about the ZX7-250 SERIES and is the answer not in the manual?
Questions and answers