AMC XO Instructions For Installation And Operation Manual page 7

KEYPAD
5
4
1. LED's of Volume Level of the zone
volume-only one LED will be light up.
2. Volume up / down
3. IR Receiver
Each keypad has an IR receiver for
c o n t r o l l i n g t h e a u d i o s o u r c e
equipment.
4. Power
The power button turns that keypad's
zone on and off independently of the
other zones. Pressing and holding the
power button turns all the zones off
simultaneously.
5. Mute
The mute button temporarily silences
any audio playing in that keypad's
zone.
6. Source Selection
The 8 source buttons independently
select any of the four sources ( Source
1 to 4) connected to the rear panel of
AMC XO and another four Remote
Sources (Source R5 to R8) connected
6
10
1
9
2
3
to the remote sources on the four
keypads of four zones. (R5 located at
k e y p a d o f Z o n e 1 , R 6 l o c a t e d a t
k e y p a d o f Z o n e 2 , R 7 l o c a t e d a t
keypad of Zone 3 and R8 located at
keypad of Zone 4) The selected source
button will remain lit.
7. JK1 (RJ45) (TO XS1) (Only for Zone
1~ Zone 4)
Use CAT5 cable to connect from the
JK1 of XK1 to the RJ45 connector of
XS1.
8. JK2 (RJ45) (TO ZT8)
Use CAT5 cable to connect from the
JK2 of XK1 to ZT8 or JK3 of Another
XK1.
9. JK3 (RJ45) (Another XK1)
Use CAT5 cable to connect from the
JK3 of XK1 to JK2 of Another XK1.
10. JK4 (RJ45) (This is Pre-Out) (To
Main-in)
Use CAT5 cable to connect from the
JK4 of XK1 to main-in of amplifiers or
power speakers.
6
7
8