Add-Ons/Peripherals - Panasonic CF-55 Series Operating Instructions Manual

Add-ons/Peripherals

Devices capable of being used by your computer are listed in the table below.
D e v i c e ( s )
PC cards (Modem, LAN, SCSI etc.)
Serial Devices (Mouse, Modem etc.)
Extra Memory
External Display
Printer
Speaker/Headphone
Audio device
Microphone
Using PC Cards
1 8
This computer has two PC Card slots. These slots conform to the PC Card Standard, and
therefore, communications and SCSI devices can be utilized. The slot allows you to use two
Type I or Type II cards (or one Type I and one Type II), or one Type III card.
Two cards can be used simulta-
neously.
Back of the card
B a c k
C A U T I O N
Please check the PC cards' specifications. Be sure the total operating current does not
exceed the specified limit, damage may result.
Allowable current (total for two slots) : 3.3 V: 400 mA, 5 V: 400 mA, 12 V: 120 mA
There are times when both a Type I card and a Type II card will not work simulta-
neously.
Some PC cards, example shown below, can not be used. The PC card's cable connector
determines its physical compatibility.
SRAM and FLASH ROM cards (except for ATA interface) are not supported.
When using a CardBus type card, use only that card; do not insert any other PC Cards.
Only the back slot can support a Zoomed Video (ZV) card. When you use a Zoomed
Video card, the driver software is needed.
W h e r e t o c o n n e c t
PC Card Slots
Serial Port
RAM Module Slot
Ext. Display Port
Parallel Port
Headphone Jack
Audio-in Jack
Microphone Jack
I II
Type or
PC Card Eject Button
I
Type or Type
F r o n t
R e f e r e n c e
III
Type
One card can be used only in the
back slot.
III
Type
II
Card
B a c k F r o n t
below
page 37
page 20
page 21
page 21
page 37
page 37
page 37
Card