Advertisement
PAN AND TILT ADJUSTMENT
To pan your luminaire loosen the yoke nut and adjust, then retighten. To tilt, loosen the locking clamp handle
on the side of the luminaire, tilt and retighten finger tight.
Please note that as the HUI Cycs and Floods can reach high temperatures depending on the
position or orientation of the luminaire, gloves should always be worn when focusing these
luminaires.
COLOUR FILTER HOLDER
Please note that the colour frame has been specially designed to tension the colour filter in the colour
cassette, and prolong the colour filter life. Special care should be taken to cut the colour filter to the
correct size of 264mm x 202mm. If the colour filter is cut to the wrong size, or positioned incorrectly, its
life will be drastically shortened.
To remove the colour frame, open the hinged door at the top of the colour cassette and lift
out the frame. Use the colour frame as a template to cut a colour filter to the exact size of
264mm x 202mm.
Position the colour filter in the colour frame, taking care to align it correctly, and checking
to ensure it is the correct size. It must not have any folds or wrinkles. Carefully insert it
into the colour cassette and close the hinged door.
HUI
JOINING SINGLE
HUI
USING THE
AS A GROUNDROW
Put the 2 groundrow screw jack feet (Order Code 15HLGDSF) in the
threaded holes on the underside of the luminaire. Swing the yoke to the
rear of the luminaire, and position to lift the luminaire off the ground. Adjust
the focus by screwing the feet.
WARNING: In the groundrow position the luminaire runs hot, please ensure it is placed on a suitable
surface.
Version 2: December 2008
UNITS TOGETHER TO MAKE BATTENS
HUI
Single
units can be joined together to make multi unit battens. To join units
together, position the yokes in the vertical position, and lock off. Place the Hui
units side by side and slide the slot lock bars (Order Code 15HLJ) into the top
and bottom join slots. Tighten the slot lock nuts with a wrench.
Repeat until the desired number of units are joined. For every four single units
joined together there must be at least two hookclamps mounted on the
lighting bar.
HUI
The
can also be used as a groundrow. To modify the
operation, reverse the colour cassette assembly by removing the two screw pivot
hinges located on each side of the luminaire. Invert the colour cassette, then
replace the two screws in the new hinge position.
© 2008 Selecon New Zealand Limited All Rights Reserved
HUI
for groundrow
Advertisement
