Specifications - Sony STR-DE335 Operating Instructions Manual

Specifications

Audio power specifications
POWER OUTPUT AND TOTAL
HARMONIC DISTORTION
With 8-ohm load, both
channels driven, from 20
20,000 Hz, rated 100 watts
per channel minimum RMS
power, with no more than
b)
0.09 % total harmonic
distortion from 250
milliwatts to rated output.
STR-SE391:
a) 40 Hz
b) 0.5 %
Amplifier section
Stereo mode
STR-DE335:
(8 ohms at 20 Hz - 20 kHz
less than 0.09% total
harmonic distortion)
100 W + 100 W
STR-SE391:
(8 ohms at 40 Hz - 20 kHz
less than 0.5% total
harmonic distortion)
100 W + 100 W
Surround mode STR-DE335:
and 5.1 CH/DVD (8 ohms at 1 kHz, THD
mode 0.8 %)
Front: 80 W/ch
Center: (Pro Logic Mode)
80 W
Rear: 80 W/ch
STR-SE391:
(8 ohms at 1 kHz, THD
0.5 %)
Front: 80 W/ch
Center: (Pro Logic Mode)
80 W
Rear: 80 W/ch
Frequency PHONO: RIAA
response equalization curve
±0.5 dB
(STR-SE391 only)
TV/SAT, CD, MD/TAPE,
VIDEO, 5.1 CH/DVD:
10 Hz - 50 kHz ±1 dB
Inputs
Sensitivity
PHONO
(STR-
4 mV
SE391
only)
CD,
5.1 CH/
DVD,
250 mV
MD/TAPE,
TV/SAT,
a)
VIDEO
-
Outputs MD/TAPE REC OUT:
Voltage: 150 mV,
Impedance: 10 kilohms
VIDEO AUDIO OUT:
Voltage: 150 mV,
Impedance: 10 kilohms
WOOFER:
Voltage: 2 V
Impedance: 1 kilohms
PHONES: Accepts low
and high impedance
headphones
Full mute
Muting
+10 dB at 70 Hz
BASS BOOST
TONE ±8 dB at 100 Hz and
10 kHz
Tuner section
FM stereo, FM/AM superheterodyne tuner
FM tuner section
Tuning range
87.5 - 108.0 MHz
Antenna terminals
75 ohms, unbalanced
Intermediate
10.7 MHz
frequency
Sensitivity
Mono: 18.3 dBf, 4.5 µV
Stereo: 38.3 dBf, 45 µV
Usable sensitivity
11.2 dBf, 2 µV (IHF)
S/N
Mono: 76 dB
Stereo: 70 dB
Harmonic
Mono: 0.3 %
distortion at 1 kHz
Stereo: 0.5 %
Separation
45 dB at 1 kHz
Frequency
30 Hz - 15 kHz
response
Selectivity
60 dB at 400 kHz
Additional Information
AM tuner section
Tuning range
Impedance S/N
50
70 dB
kilohms
Antenna
Intermediate
50
80 dB frequency
kilohms
Usable sensitivity
S/N
Harmonic
distortion
Selectivity
* You can change the AM tuning interval
between 9 kHz and 10 kHz. Turn off the
receiver and press 1/u (power) for more
than 4 seconds until "INITIAL" appears.
1) After tuning in any AM station, turn
off the receiver.
2) Hold down PRESET TUNING + button
and press the 1/u (power) button.
"9k STEP" appears.
To change to 10k Step, repeat step 1 and 2
until "10k STEP" appears. Note that all
preset stations, index names and sound field
are cleared after you make the procedure
above.
Video section (STR-DE335 only)
Inputs
Outputs
General
System
Power
+0.5
dB
requirements
–2
Power
consumption
10 kHz interval*
530 - 1710 kHz
9 kHz interval
531 -1710 kHz
Loop antenna
450 kHz
50 dB/m (at 1,000 kHz or
999 kHz)
54 dB (at 50 mV/m)
0.5 % (50 mV/m,
400 Hz)
At 9 kHz: 35 dB
At 10 kHz: 40 dB
VIDEO, TV/SAT, 5.1
CH/DVD:
1 Vp-p 75 ohms
VIDEO, MONITOR:
1 Vp-p 75 ohms
Tuner section: PLL
quartz-locked digital
synthesizer system
Preamplifier section:
Low-noise NF type
equalizer
Power amplifier
section: Pure-
complementary SEPP
120 V AC, 60 Hz
230W
(continued)
21