Convergence Point - Sharp 50NP4 Service Manual

NOTES:
(1) EXIT button- Crosshatch/Video mode
Press ÒEXITÓ 5 times to display external signal.
Press ÒEXITÓ 5 times again to return to DCU
internal cross-hatch signal.
(2) MENU button- Remove color mode
Press MENU to switch between all colors
displayed or adjustment color and green only.
Press (0), then press MENU- REd and Green
displayed (Blue removed).
Press INPUT, then press MENU- Blue and
Green are displayed (Red removed).
Press DISPLAY, then press MENU- Only Green
is displayed.
(3) FREEZE button- ENTER/EXIT raster position
adjustment mode.
Adjustment Prepartion
(1) Position adjustment- This will move an entire
color.
(2) Use the buttons below to switch color to adjust.
DISPLAY- Green
0- Red
INPUT- Blue
Adjustment Procedure
(1) Press the FREEZE button.
lines appear to confirm raster position mode.
(2) Use the cursor buttons to adjust.
(3) Press FREEZE again to exit raster position
mode.
NOTES: 1. Other functions cannot be accessed when in
raster position adjustment mode.
FREEZE and confirm extra horizontal lines
disappear to exit raster position mode.
2. Press MENU to switch between all colors
displayed or adjustment color and Green
only.
ADJUSTMENT
CURSOR UP
CURSOR LEFT
Extra horizontal
Press
44
2.12.3 Digital Convergence Remote Control (SP0X)
CURSOR
DOWN
RED
(7x5 Adj.)
ROM
READ
NOTES: 1. Above functions are executed only when
remote is in TV mode. First press the TV
button on R/C to select the TV mode.
2. 3x3 adjustment mode can be accessed only
when DCU is in uncorrected state.
CALCULATION
REMOVE
COLOR
PHASE
REMOVE
COLOR
CURSOR
RIGHT
ROM
WRITE
RASTER
POSITION
GREEN
(3x3 adj.)
BLUE
(13x9 adj.)