Sony SDM-N50PS Service Manual page 10

Installing the display vertically
This display can be installed either horizontally or vertically using
the supplied display stand.
To switch to the horizontal or vertical viewing
position
First install the supplied WinPortrait (for Windws 95/98 and
NT4.0) or MacPortrait (for Macintosh). To switch the view, press
Shift + Ctrl + R on the keyboard. For more information, see the
supplied software's instruction manual.
To install the display horizontally or vertically
Open the display stand until the click sound is heard.
Put the display on the stand, aligning the mark which shows the
stand position on the display.
Horizontal installation
The stand positioning mark
Vertical installation
The stand positioning mark
10
To close the display stand
While sliding the stopper up, close the display stand.
The stopper
Using the headphones
You can listen to the audio signals from your computer or other
audio equipment using headphones.
Connect the AUDIO IN jack to the audio output jack of your
computer or other audio equipment using the supplied audio cord.
Adjusting the volume
1 Press the 2 +/– buttons.
The VOLUME menu appears on the screen.
VOL UME
,
4 0
Press the 2 +/– button to adjust the volume.
2
The menu automatically disappears after about 3 seconds.
Notes
• You cannot adjust the volume when displaying the main menu on the
screen.
• When your monitor is in power saving mode, no sound comes from the
headphones.
Selecting the on-screen menu
language (LANGUAGE)
English, German, French, Spanish, Italian, and Japanese versions
of the on-screen menus are available. The default setting is
English.
1
Press the MENU button.
PHA S E
MENU
,
1 6
EX I T
2
Press the M (+)/ m (–) buttons to select m .
B A S S BOOS T
ON
O F F
,
EX I T
3 Press the M (+)/ m (–) buttons to select
(LANGUAGE) and press the OK button.
L A NGU AGE
E N G L I S H
INPUT D E U T S C H
F R A N Ç A I S
, 1 ,
E S P A Ñ O L
2
I T A L I A N O
OK
EX I T
4 Press the M (+)/ m (–) button to select a language.
• ENGLISH
• DEUTSCH: German
• FRANÇAIS: French
• ESPAÑOL: Spanish
• ITALIANO: Italian
• : Japanese
To close the menu
Press the MENU button once to return to normal viewing. If no buttons
are pressed, the menu closes automatically after about 30 seconds.
Selecting the input signal
You can connect two computers to this monitor using the INPUT
1 and INPUT 2 connectors. To select one of the two computers,
use the INPUT button.
Press the INPUT button.
The input signal and corresponding input indicator, "1" (INPUT
1) or "2" (INPUT 2) change each time you press this button.
INPUT
1
2
OK
Notes
• You cannot select the input signal when displaying the main menu on
the screen.
• If no signal is input to the selected connector, NO INPUT SIGNAL or
CABLE DISCONNECTED appears on the screen. After a few seconds,
the monitor enters the power saving mode. If this happens, select the
other connector using the INPUT button.
11
GB