Sony MHC-GZX88D Operating Instructions Manual page 49

• The bit rate used when encoding audio
files was low. Send audio files with
higher bit rate to the USB device.
"READING" is displayed for an
extended time, or it takes a long time
before playback starts.
• The reading process can take a long time
in the following cases.
– There are many folders or files on the
USB device (page 8).
– The file structure is extremely
complex.
– The memory capacity is excessive.
– The internal memory is fragmented.
"OVER CURRENT" appears in the
display panel.
• A problem has been detected with the
level of electrical current from the
port or B port. Turn off the system
and remove the USB device from the
port. Make sure there is no problem with
the USB device. If this display pattern
persists, contact your nearest Sony
dealer.
Erroneous display.
• The data stored in the USB device may
have been corrupted, perform the
transferring again.
• The character code that can be displayed
by this system are as follows:
– Upper cases (A to Z)
– Numbers (0 to 9)
– Symbols (< > * +, [ ] \ _)
Other characters appear as "_".
The USB device is not recognized.
• Turn off the system and reconnect the
USB device, then turn on the system.
• Check the information on the websites
about compatible USB devices
(page 9).
• The USB device does not work
properly. Refer to the operating
instructions of the USB device on how
to deal with this problem.
Playback does not start.
• Turn off the system and reconnect the
USB device, then turn on the system.
• Check the information on the websites
about compatible USB devices
(page 9).
Playback does not start from the first
file.
• Set the play mode to Normal Play.
Files cannot be played back.
• The JPEG image file is larger than
3,072 (width) × 2,048 (height) in normal
mode, or more than 3,300,000 pixels in
Progressive JPEG mode which is
mainly used on the Internet website.
• JPEG image files with a high width to
length ratio cannot be played back.
• Make sure you have selected the correct
A
Media Mode before playback.
• USB device formatted with file systems
other than FAT16 or FAT32 are
unsupported.*
• A WMA audio file that is the WMA
DRM, WMA Lossless, or WMA PRO
format cannot be played back.
• An AAC audio file that is the AAC
DRM or AAC Lossless format cannot
be played back.
• AAC audio files encoded at 96 kHz
cannot be played back.
• If you use a partitioned USB device,
only files on the first partition can be
played back.
• The system can play back to a depth of
8 folders only.
• The number of folders has exceeded
300.
• The number of files has exceeded 2,000.
• Files that are encrypted or protected by
passwords, etc. cannot be played back.
• The MP3 PRO audio file can be played
back as MP3 audio file.
* This system supports FAT16 and FAT32, but
some USB devices may not support all of
these FAT. For details, refer the operating
instructions of each USB device or contact the
manufacturer.
GB
49